Whirlpool Dryer Error Code Blocked coin 2

The Blocked coin 2 error indicates a fault in the second coin drop circuit of a coin-operated Whirlpool dryer. It can mean either a physical blockage in the coin chute or a failure in the UI control circuit that handles coin recognition. While the error is active, coin recognition and the customer display are disabled. The machine will not accept coins until the blockage or circuit fault is resolved.

A power reset may temporarily clear the error code from the display, but it will return if the underlying cause is not addressed. If a physical blockage is present, the error will reappear as soon as the machine attempts to read the coin circuit again. A lasting fix requires identifying and correcting the root cause, whether mechanical or electrical.

Repair costs vary depending on the root cause. Clearing a simple physical blockage may cost little to nothing if done without a service call. Replacing a coin acceptor sensor or assembly typically ranges from around $50 to $150 in parts, with labor added if a technician performs the work. A UI control board replacement is the most expensive scenario, with parts and labor potentially totaling $150 to $350 or more depending on the specific model and service rates in your area.

Start by inspecting the second coin drop chute for any lodged coins, tokens, or debris and clear any obstructions found. If the chute is clear, check the wiring harness connected to the coin acceptor for loose, corroded, or damaged connectors. If wiring appears intact, the coin acceptor sensor or the UI control board may need to be tested and potentially replaced by a qualified technician.

The error disables coin recognition and the customer display, so users will not be able to start a paid cycle through the coin mechanism while the fault persists. The error is specific to the coin control circuit and does not inherently indicate a safety hazard with the heating or drum systems. However, the machine should be inspected promptly to prevent further damage to the coin acceptor or control board components.