Whirlpool Dryer Error Code E:22

E:22 is a Control Fault 2 error, meaning the dryer's main control board has detected an internal fault within itself. The board's self-diagnostic system has flagged a problem it cannot recover from on its own. This error points directly to the control board as the source of the problem, not to an external sensor or component.

A power reset, such as unplugging the dryer for several minutes, may temporarily clear the fault display, but E:22 will typically return if the control board has a genuine internal failure. If the error comes back after a reset, the control board needs to be inspected and most likely replaced. A reset alone is not a fix for this fault.

The cost to fix E:22 depends primarily on the price of the replacement control board, which typically ranges from $80 to $250 or more depending on the specific dryer model. If you hire a technician, labor costs will add to the total, generally bringing the repair to a range of $150 to $400 or more. Checking wiring connections first costs nothing and is worth doing before purchasing a new board.

A knowledgeable DIYer can attempt to resolve E:22 by first checking all wiring harness connections at the control board for looseness or corrosion. If connections are secure and the fault persists, replacing the control board is the required repair. Board replacement involves disconnecting wiring harnesses and mounting hardware, which is manageable for someone comfortable working with appliance electronics.

When E:22 is active, the dryer's control board may not operate reliably, which means the dryer could behave unpredictably or fail to complete cycles safely. It is best to avoid using the dryer until the fault is diagnosed and the control board is repaired or replaced. Continuing to run a dryer with a faulty control board carries risk of improper operation.