mypros+
Model reference

Whirlpool WTVC5330US

Dryer

1 document17 error codes9 service modes

Available documentation

Service Manual

  • Selecting the test program1 pg
    Covers this model
MyPros+ Max

Diagnose your Whirlpool WTVC5330US.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (17)

CodeMeaning
CLnOverheat warning due to reduced air flow, lint clog, or duct work not meeting…E:03Maximum heating time exceeded due to load too large or defective heater…E:11Overheat warning (service display code corresponding to customer CLn display)…E:12Overheat error due to reduced air flow or lint clog; maximum heating time…E:13Maximum heating time exceeded (customer display for service code E:03); load…E:14No heat detected; heater not igniting (gas) or defective heater (electric).E:15Continued heat detected due to stuck heater relay.E:16Broken drive belt detected; faulty drive belt.E:17T4 error (drum exit thermocouple)E:18T2 error (heating element thermocouple)E:20EEPROM/Dry Table error due to defective interface or PROM.E:21Invalid checksum due to incomplete update or defective PROM.E:22Invalid update due to incomplete update.E:23Variant–Table Set Mismatch; invalid table set or variant.E:24Base software does not correspond to table set; invalid table set or variant.E:25Damaged dry table; missing end command.E:26Controller error determined by supplier.

Service modes (9)

  • Consumer Test (Test Program 5)["Enter test mode.","Turn selector 5 positions clockwise from OFF.","Press Start/Pause to start."]
  • Control Elements Test (Test Program 4)["Enter test mode.","Turn selector 4 positions clockwise from OFF.","Press Start/Pause to start."]
  • Display Test (Test Program 3)["Enter test mode.","Turn selector 3 positions clockwise from OFF.","Press Start/Pause to start."]
  • Error Codes (Test Program 1)["Enter test mode.","Turn selector 1 position clockwise from OFF.","Press Start/Pause to enter…
  • In-Factory Test["Enter test mode.","Turn selector 1 position counterclockwise from OFF.","Press Start/Pause to…
  • Moisture Sensor Measurement (Test Program 6)["Enter test mode.","Turn selector 6 positions clockwise from OFF.","Press Start/Pause to start."]
  • Safety Test (Test Program 2)["Enter test mode.","Turn selector 2 positions clockwise from OFF.","Press Start/Pause to start."]
  • Sales Demo Program (Test Program 7)["Enter test mode.","Turn selector 7 positions clockwise from OFF.","Press Start/Pause to start."]
  • Test Mode (Diagnostic)["Set program selector switch to OFF position.","Press and hold Start/Pause and ECO Action…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Whirlpool dryer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass