Whirlpool Dryer Error Code E:25

E:25 is a Control Fault 2 code, meaning the dryer's main electronic control board has detected an internal fault within its own circuitry. The board's self-diagnostic system has identified that it is not functioning correctly. This code points directly to the control board rather than an external sensor or component.

A power reset, such as unplugging the dryer for a few minutes, may temporarily clear the E:25 code if the fault was caused by a transient power issue. However, if the control board has sustained actual internal damage or has a genuine hardware fault, the error will return after the reset. A persistent E:25 after multiple resets indicates the board needs to be replaced.

The cost depends on whether you hire a technician or perform the repair yourself. A replacement control board typically ranges from roughly 80 to 200 dollars depending on the specific model. If a professional technician is hired, labor costs will add to that figure, bringing the total repair estimate to approximately 150 to 350 dollars or more depending on your location and service provider.

The fix for E:25 is replacement of the electronic control board. A knowledgeable DIYer comfortable working with appliance electronics can perform this repair by disconnecting power, removing the board, and installing a replacement unit. However, if you are unfamiliar with handling circuit boards or appliance wiring, a professional technician is recommended.

It is not advisable to continue operating the dryer while E:25 is active. A faulty control board can cause unpredictable behavior, including improper heating control or failure to shut off correctly, which could pose a safety risk. The dryer should be taken out of service until the control board is inspected and replaced.