Whirlpool Dryer Error Code F:44

F:44 indicates a motor control electronics failure on a Whirlpool dryer. The motor control board, which regulates power to the drive motor, has detected an internal fault and shut down operation. This code requires diagnostic testing of the motor control circuit, starting with TEST #3b, to determine whether the board itself or an associated component is at fault.

No, you should not continue operating the dryer when F:44 is displayed. The motor control electronics failure means the dryer has already stopped functioning to protect itself, and running it in a fault state risks further damage to connected components. Leave the dryer off until the motor control circuit has been properly diagnosed and repaired.

A reset by unplugging the dryer for a few minutes may temporarily clear the F:44 code, but if the underlying motor control electronics failure is still present, the fault will return when the dryer is operated again. Resetting is not a fix and should only be done as part of a diagnostic process to confirm whether the fault is persistent or intermittent.

Some aspects of diagnosis are accessible to experienced DIYers, such as inspecting wiring connections and checking for blocked venting. However, testing the motor control board circuit properly requires familiarity with electrical testing procedures and safety precautions around high-voltage dryer components. If the motor control board itself has failed, replacing it involves working near live voltage points, so professional service is recommended if you are not comfortable with appliance electrical work.

Repair costs vary depending on what is found during diagnosis. If only a wiring connection needs to be repaired or reseated, costs may be minimal beyond a service call fee, typically in the range of $75 to $150. If the motor control board requires replacement, parts and labor combined can range from $150 to $350 or more depending on the specific model and local labor rates.