Whirlpool Dryer Error Code UI EEPROM CRC failure

This error means the user interface control board has detected a cyclic redundancy check failure in its EEPROM memory, indicating the stored data is corrupted or unreadable. As a protective response, the dryer disables the display until the code is manually cleared through the diagnostic mode. It can be caused by a power surge, component wear, or a failing UI board.

When this error is active, the dryer display is disabled and normal user input is not functional, so the dryer cannot be operated in its standard mode. You should not attempt to bypass the fault for routine drying until the code has been properly cleared and the root cause addressed. There is no direct fire or electrical hazard from this specific error, but operating with a non-functional control interface is not recommended.

Start by entering the dryer's diagnostic mode and manually clearing the fault code as specified for your model. After clearing, observe whether the error returns during normal operation. If it does not return, inspect the power supply and outlet for signs of voltage instability. If the error reappears quickly, the user interface control board should be tested and likely replaced.

The error must be cleared manually through the dryer's diagnostic mode rather than a simple power reset. If the fault was triggered by a one-time event such as a power surge, clearing it through diagnostics may resolve the issue permanently. However, if the underlying UI board or EEPROM chip has failed, the code will return shortly after being cleared.

If the error clears after a manual diagnostic reset and does not return, there may be no parts cost at all. If the user interface control board needs replacement, parts alone typically range from $75 to $200 depending on the specific model, with additional labor costs if a technician performs the repair. Diagnosing whether the board is truly at fault before purchasing parts can help avoid unnecessary expense.