Whirlpool Washer Dryer Error Code F7E7

F7E7Whirlpool Washer Dryer

What this code means

Motor unable to reach target RPM – basket speed sensor detects that target RPM was not reached.

First step from the service manual

See TEST #3: Drive System, page 13; check for mechanical friction on drive mechanism or basket; check motor run capacitor.

Next steps: diagnose the root cause

1
Verify the error code is active

Power cycle the unit and see if the code returns. If it does, the fault is persistent and requires diagnosis.

2
Get the full diagnostic procedure

Get step-by-step guidance, test values, and wiring diagrams from the OEM service manual.

Start diagnosing F7E7 on your Whirlpool washer dryer

$29/month · Cancel anytime · Or $9.95 3-day pass

What’s available for Whirlpool washer dryer models

Access Whirlpool washer dryer service manuals, wiring schematics, exploded parts views, and error code references on MyPros+.

Related Whirlpool washer dryer error codes

3 STATUS LEDs flashingPower failure occurred during a dryer cycle - Drying + Cool Down + Finish Guard...88888LED test mode is active; all LEDs are lit and all display segments are...Drying (flashing) or Cool Down (flashing) or Finish Guard (flashing)The dryer door has been opened during a cycle (single STATUS LED flashing).Drying + Cool Down + Finish Guard (flashing)A power failure occurred during a dryer cycle.E1Low/No water fill - water level does not reach the lowest level within 10...E2Abnormal drain - washer fails to reach the reset level after draining the water...E3Abnormal spin - tub strikes the tub switch several times without balancing...E4Lid open – washer lid is opened or the lid switch is open at the start of the...
STOP GUESSING·Start verifying

Start diagnosing faster today.

$29/month · Cancel anytime · Or $9.95 3-day pass

Get Started