Whirlpool Washer Error Code 27

Error code 27 means the washer detected water remaining in the tub with the door open for more than 15 minutes during a cycle. This is a Water Accessibility fault designed to alert you to an abnormal water condition. It most commonly points to a leaking water inlet valve, a drain problem, or a faulty door switch sending incorrect signals to the control board.

It is not recommended to continue running the washer while error code 27 is active. A leaking inlet valve or standing water with the door open creates a risk of water damage or overflow. Diagnose and repair the underlying cause before resuming normal use.

Repair costs vary depending on which component is at fault. A replacement water inlet valve typically costs between $20 and $80 for the part, while a door latch assembly or pressure sensor generally falls in a similar range. If professional labor is involved, total repair costs including parts and service fees commonly range from $100 to $300 depending on your location and the specific repair needed.

Start by checking the water inlet valves for any signs of leaking or dripping when the machine is not filling. Next, inspect the drain hose and pump filter for blockages that could leave standing water in the tub. If the valves and drain system appear normal, test the door latch and door switch for proper continuity, and check the water level pressure sensor. Replacing the faulty component should clear the error.

A reset may temporarily clear the code and allow the washer to restart, but if the underlying problem is not fixed, the error will return. Resetting is useful for ruling out a one-time glitch, but a recurring code 27 requires inspection and repair of the water inlet valve, drain system, door switch, or pressure sensor.