Whirlpool Washer Error Code 60

Error code 60 on a Whirlpool washer indicates an accelerometer fault, meaning the accelerometer board has reported a fault condition to the main control. The accelerometer is a sensor that monitors drum motion and vibration during the spin cycle. The washer cannot confirm reliable sensor data and stops operation until the issue is diagnosed and resolved.

A basic power reset alone is unlikely to permanently clear code 60 if there is an actual hardware problem with the accelerometer board or its wiring. The recommended first step is to run service mode test 11 to full completion, which gives the control system a proper opportunity to evaluate and potentially clear the fault under controlled spin conditions.

If the fix is simply reseating a loose connector, there may be no parts cost at all. Replacing the accelerometer board typically costs between $50 and $150 for the part, plus labor if a technician is performing the repair. If the main control board is the root cause, repair costs can range from $150 to $350 or more depending on the specific model and labor rates in your area.

Start by running service mode test 11, the Spin Test, through to full completion. This can clear the fault if the cause was a transient electrical event. If the code returns, inspect the wiring harness and connectors leading to the accelerometer board, reseating any loose connections. A persistently failing accelerometer board will need to be replaced.

It is not recommended to continue using the washer while code 60 is active. The accelerometer monitors drum vibration and balance during the spin cycle, and without reliable data from this sensor, the washer cannot protect itself or your laundry from excessive vibration or an out-of-balance spin condition. Continued use could cause further damage.