Whirlpool Washer Error Code d:06

The d:06 code means the washer has detected a failure in the motor control NTC relay circuit. Specifically, the control has determined that either the NTC thermistor on the motor control board is reading an excessively high temperature, or that the associated relay is stuck in the closed position. The washer stops operation to protect the motor control electronics from further damage.

No. The d:06 code indicates either an overheating condition or a stuck relay in the motor control unit, both of which represent potential safety risks. Continuing to operate the washer can cause further damage to the motor control board or the drive motor. Stop using the washer until the fault has been diagnosed and corrected.

Repair costs depend on the root cause. If the motor control board needs replacement, parts alone typically range from $100 to $300 depending on the specific model, with additional labor costs if a technician is hired. If the issue is isolated to the NTC thermistor or a ventilation problem, the repair cost will generally be lower. Getting a diagnostic inspection first will clarify exactly which component has failed.

Diagnosis requires running the built-in test P:04 and then inspecting the motor control board, NTC thermistor, and relay. A knowledgeable DIYer comfortable working with appliance electronics can perform these checks, but if the motor control board has failed internally, replacing it is the required repair. Working around motor control components involves mains voltage, so the washer must be unplugged before any hands-on inspection.

A power reset may temporarily clear the code, but if the underlying hardware fault persists, the error will return as soon as the washer attempts to operate. A reset does not repair a failed relay, a damaged motor control board, or a faulty NTC thermistor. The component issue must be addressed to permanently resolve the fault.