mypros+
Error code reference

Wolf Range Error Code 0222

Right or left oven bake/right convection element DLB relay shorted (left oven).

Avg. service call
$285
National average. Trip fee plus diagnostic plus labor. Before parts.
MyPros+ 3-day pass
$9.95
Same diagnostic steps, on your phone. Start now.
You keep in your pocket
~$275
Even before you buy the part.
Skip the service call. Fix it yourself.
Full procedure unlocks instantly.
Get Started

What the 0222 error code actually means

Your Wolf oven has detected a problem with an internal safety switch that controls power to the baking element in the left oven. This switch appears to be stuck in the "on" position, which means the oven cannot safely control when the heating element is powered. You should stop using the oven and have a qualified technician inspect it before operating it again.

Diagnostic procedure

The full 0222 procedure

Step 1 is visible so you can confirm you are on the right page. The remaining steps, the ones that tell you whether to actually replace a part, unlock with any pass.

MyPros+ · DiagnosticsStep 1 preview
1
Confirm the fault
Power cycle the unit: switch off the breaker for 60 seconds, then restore power. If the code returns, the fault is persistent and the procedure below isolates the cause.
More steps, wiring diagram references, and verified part numbers
Includes expected resistance and voltage values, connector pinouts, and supersession notes for replacement parts.
Unlock 0222 procedure $9.95

Or subscribe: $29/month for unlimited access to all codes plus Max AI diagnostics.

Most common causes of 0222

Ranked by how often they cause this code
  1. 1Failed or shorted relay board
  2. 2Shorted bake or convection heating element
  3. 3Damaged or pinched wiring harness
  4. 4Failed main control board

Most DIYers save hundreds by diagnosing before ordering parts.

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass

Questions people ask about 0222

What does 0222 mean on a Wolf range?
Error code 0222 on a Wolf range means the control has detected a shorted DLB (Double Line Break) relay in the left oven bake or right convection element circuit. The DLB relay is a safety component that cuts power to the heating element on both lines of the 240V supply. When it shorts, the control loses the ability to safely interrupt power to that element. This is considered a serious fault and the oven should not be used until it is repaired.
Is it safe to use my Wolf oven while error code 0222 is active?
No, you should not use the oven while this code is active. A shorted DLB relay means the control cannot reliably cut power to the bake or convection element, which creates a risk of uncontrolled heating or overheating in the left oven cavity. Discontinue use and have the appliance inspected before operating it again.
How much does it cost to repair error code 0222 on a Wolf range?
Repair costs vary depending on the failed component. A replacement relay board or main control board for a Wolf range typically falls in the range of $150 to $500 or more for parts alone, depending on the specific model. A bake or convection element is generally less expensive, often in the $50 to $200 range for parts. Adding professional labor, total repair costs commonly range from $200 to $700 or higher depending on your location and the extent of the diagnosis required.
Can I fix error code 0222 on my Wolf range myself?
Diagnosing and repairing this fault involves working with 240V wiring, relay boards, and heating elements, which carries significant shock and burn risk. A knowledgeable DIYer comfortable with appliance electrical work can inspect the wiring harness and check the bake element for shorts using a multimeter. However, replacing a relay board or main control board is typically best handled by a qualified appliance technician to ensure safe and correct repair.
Will resetting the oven clear error code 0222?
A power reset may temporarily clear the error code display, but it will not resolve the underlying fault. If the DLB relay is physically shorted or the element or wiring has a fault, the code will return when the oven attempts to operate. A reset should only be used as part of diagnostics, not as a repair solution.

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass