Model reference
Admiral A82LW-2K-R
Cooktop
29 error codes13 service modes
MyPros+ Max
Diagnose your Admiral A82LW-2K-R.
- Step-by-step diagnostics from the service manual
- Test values, resistance specs, and wiring references
- Verified part numbers when replacement is needed
Start diagnosing
$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax
Error codes (29)
CodeMeaning
E3The heater cannot warm the water to the desired temperature within 90 minutes…E6NTC open circuit failure (only alarmed during on-line test).E7NTC short circuit failure (only alarmed during on-line test).F0E2Over suds condition detectedF0E4High water temperature detected during rinse cycle (105°F or higher).F0E5Off balance load detected during operation.F1E1Main control fault.F1E2Motor control faultF2E1Stuck keyF2E3Mismatch of main control and UIF3E1Pressure sensor faultF3E2Inlet water temperature faultF5E1Lid switch fault (lid up)F5E2Lid lock faultF5E3Lid unlock faultF5E4Lid not opened between cyclesF7E1Basket speed sensor faultF7E5Shifter faultF7E6Motor faultF7E7Motor unable to reach target RPMF8E1No fill / long fillF8E3Overflow conditionF8E5Hot and cold inlet hoses are reversed.F9E1Long drainMemory FailureControl board memory/software failure detected during Field Service Test…Motor high currentMotor drawing excessive current detected during Field Service Test, indicated…Motor low currentMotor drawing insufficient current detected during Field Service Test…Thermistor failureThermistor failure detected during Field Service Test, indicated by Heavy Wash…Turbidity Sensor failureTurbidity sensor failure detected during Field Service Test, indicated by Rinse…Service modes (13)
- Automatic Test Mode["Enter Service Diagnostic Test Modes.","Turn cycle selector knob until Spin LED is On (display…
- Calibration Mode["Enter Service Diagnostic Test Modes.","Turn cycle selector knob until Rinse LED is On (display…
- Fault Code Display Mode["Enter Service Diagnostic Test Modes.","Turn cycle selector knob until Done LED is On (display…
- Field Service TestPress the Heavy Wash key 5 times followed by the Start key within 6 seconds.
- Manual Function TestPress the Normal Wash key 5 times followed by the Start key within 6 seconds
- Manual Test Mode["Enter Service Diagnostic Test Modes.","Turn cycle selector knob until Spin & Done LEDs are On…
- On-Line Check Mode (Service Diagnostics Cycle)1
- Sales Floor Demo ModePress Extra Rinse keypad 5 times within 6 seconds.
- Service Diagnostic Test Modes (Entry)["Ensure washer is in standby mode (plugged in with all indicators off).","RESET
- Service Mode (Keypad/LED Test)Close the door, then within 60 seconds press RINSE ONLY and START/RESUME
- Software Version Display Mode["Enter Service Diagnostic Test Modes.","Turn cycle selector knob until Rinse, Spin, and Done LEDs…
- Tachometer Verification Mode["Enter Service Diagnostic Test Modes.","Turn cycle selector knob until Wash and Done LEDs are On…
- UI Test Mode["Enter Service Diagnostic Test Modes.","Turn cycle selector knob until Rinse & Spin LEDs are On…
Full entry steps, exit procedures, and test sequences are available in Max.
Related Admiral cooktop models
75,000+ service documents · 20,000+ error codes · 100+ brands
Get Started$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax