mypros+
Model reference

Amana 11-5J

Air Conditioner

1 document69 error codes51 service modes

Available documentation

Other

  • 431716993 pg
    Covers this model
MyPros+ Max

Diagnose your Amana 11-5J.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (69)

CodeMeaning
F0E0No fault detected (GOOD)F1 E0EEPROM read fault (silent fault, not displayed).F1 E1EEPROM checksum does not match at start key (silent fault, not displayed).F1 E3Configuration jumper changeF1 E4Q8 shorted.F1 E9Stack overflow, highest priority fault.F1-E0EEPROM read fault (silent fault, not displayed).F1-E1EEPROM checksum does not match at start key (silent fault, not displayed).F1-E3Configuration jumper changeF1-E4Q8 shorted.F1-E9Stack overflow, highest priority fault.F1E0Replace oven User InterfaceF1E1Oven Appliance Manager failure (not applicable for lower oven on double oven…F2 E0Cancel key level too low (open).F2 E2Cancel key loop test failed.F2 E3Key held down too long or keyboard short.F2 E4Keys unsettled, probably due to noise.F2-E0Cancel key level too low (open).F2-E2Cancel key loop test failed.F2-E3Key held down too long or keyboard short.F2-E4Keys unsettled, probably due to noise.F2E0Keypad disconnected.F2E1Stuck key or shorted key.F2E2LED error.F2E3Keypad hardware failure.F3 E0Oven temperature sensor (PLAT sensor) open.F3 E1Oven temperature sensor (PLAT sensor) shorted.F3 E2Oven temperature too high (runaway).F3-E0Plat (oven temperature) sensor open.F3-E1Plat (oven temperature) sensor shorted.
View all 69 error codes
F3-E2Oven temperature too high (runaway condition).F3E0Upper oven sensor open, shorted or grounded.F3E1Lower oven sensor shorted or open.F3E2Warming drawer sensor shorted (oven is not equipped with this feature…F3E3Meat probe shorted.F4 E1Meat probe shorted (less than 1500 ohms).F4-E1Meat probe shorted (less than 1500 ohms).F4E1Convection thermistor fault (microwave oven sensor).F4E2Internal temperature sensor fault (microwave oven sensor).F4E4Humidity sensor fault (microwave oven sensor).F5 E1Self-clean latch will not make after 30 seconds.F5 E3Loss of 120 VAC across L1 to ground, or Q19 circuit error.F5 E5Self-clean temperature not satisfied after 30 minutes.F5 E6Door locked with door open.F5 E7Door unlocked and will not unlatch.F5-E1Self-clean latch will not make after 30 seconds.F5-E3Loss of 120 VAC across L1 to ground, or Q19 circuit error (non-polarized…F5-E5Self-clean temperature not satisfied after 30 minutes.F5-E6Door locked with door open.F5-E7Door unlocked and will not unlatch.F5E0Door and latch switch do not agree.F5E1Door latch not operating.F6 E0Ambient sensor opened (too hot).F6-E0Ambient sensor opened (too hot).F6E0Lost communications between user interface and appliance manager.F6E1Cook oven over temperature.F6E2Clean oven over temperature.F6E3Mini oven/warm drawer over temperature (function not present on this oven).F6E4User interface / appliance manager mismatch.F6E5No cavity size command programmed.F7 E0Input switches will not follow their strobe level (shorted to ground).F7-E0Input switches will not follow their strobe level (shorted to ground).F7E0Water level is not high enough or water did not boil fast enough.F7E4Conductivity sensor not connected.F8E0Low fan speed underspeedF8E1Low fan speed overspeedF8E2High fan speed underspeedF8E3High fan speed overspeedPFPower failure indication (not a failure of control).

Service modes (51)

  • Control Programming - Convection Freestanding/Slide-In["Power up the unit","Press Convection Broil","Press Clean","Press Baked Goods","Press Stop…
  • Control Programming - Non-Convection Freestanding/Slide-In["Power up the unit","Press Clean","Press Stop Time","Press #0","Press Oven Light","Press…
  • Convection Freestanding/Slide-In Board ProgrammingAfter powering up the unit, press the following keypads in sequence
  • Convection Freestanding/Slide-In Control ProgrammingAfter unit is powered up, press the following keypad sequence
  • Diagnostic modePress OFF, OFF, START to enter diagnostic mode and check fault codes.
  • Diagnostics Mode["Plug in oven or connect power.","Press LIGHT > KITCHEN TIMER > LIGHT 3 times within 8 seconds."]
  • Extended diagnostic mode (relay activation and testing)1
  • Hidden Function - Calibration["Press and hold the Bake keypad for 5 seconds"]
  • Hidden Function - Clock Display Off["Press and hold the Clock keypad for 5 seconds"]
  • Hidden Function - Dehydrate["Press and hold the Conv
  • Hidden Function - End-of-Cycle Tones Off["Press and hold the Cook Time keypad for 5 seconds"]
  • Hidden Function - Fahrenheit/Celsius Toggle["Press and hold the Broil keypad for 5 seconds"]
  • Hidden Function - Keypad Entry Tones Off["Press and hold the Stop Time keypad for 5 seconds"]
  • Hidden Function - Keypad Lockout["Press and hold the #3 keypad for 5 seconds"]
  • Hidden Function - Last Error Code / ROM Revision["Press and hold the #0 keypad for 5 seconds"]
  • Hidden Function - Raising Bread["Press and hold the Baked Goods keypad for 5 seconds"]
  • Hidden Function - Range Configuration Display["Press and hold the #1 keypad for 5 seconds"]
  • Hidden Function - Sell Mode["Press and hold the Timer Cancel keypad for 5 seconds"]
  • Hidden Function - Timer Operating Tones Off["Press and hold the Timer Start keypad for 5 seconds"]
  • Hidden Function - Tone Frequency Change["Press and hold the #7 keypad for 5 seconds"]
  • Hidden Functions - Bake Temperature CalibrationTouch and hold the Bake keypad for 5 seconds.
  • Hidden Functions - Calibration (Bake keypad)Touch and hold the Bake keypad for 5 seconds.
  • Hidden Functions - Clock Display OffTouch and hold the Clock keypad for 5 seconds.
  • Hidden Functions - Clock Display Off (Clock keypad)Touch and hold the Clock keypad for 5 seconds.
  • Hidden Functions - DehydrateTouch and hold the Conv
  • Hidden Functions - Dehydrate (Conv. Bake keypad)Touch and hold the Conv
  • Hidden Functions - End-of-Cycle Tones OffTouch and hold the Cook Time keypad for 5 seconds.
  • Hidden Functions - End-of-Cycle Tones Off (Cook Time keypad)Touch and hold the Cook Time keypad for 5 seconds.
  • Hidden Functions - Fahrenheit/Celsius ToggleTouch and hold the Broil keypad for 5 seconds.
  • Hidden Functions - Fahrenheit/Celsius Toggle (Broil keypad)Touch and hold the Broil keypad for 5 seconds.
  • Hidden Functions - Keypad Entry Tones OffTouch and hold the Stop Time keypad for 5 seconds.
  • Hidden Functions - Keypad Entry Tones Off (Stop Time keypad)Touch and hold the Stop Time keypad for 5 seconds.
  • Hidden Functions - Keypad LockoutTouch and hold the #3 keypad for 5 seconds.
  • Hidden Functions - Keypad Lockout (3 keypad)Touch and hold the #3 keypad for 5 seconds.
  • Hidden Functions - Last F/E Code and ROM RevisionTouch and hold the #0 keypad for 5 seconds.
  • Hidden Functions - Last F/E Code and ROM Revision (0 keypad)Touch and hold the #0 keypad for 5 seconds.
  • Hidden Functions - Raising Bread (Baked Goods keypad)Touch and hold the Baked Goods keypad for 5 seconds.
  • Hidden Functions - Raising Bread DoughTouch and hold the Baked Goods keypad for 5 seconds.
  • Hidden Functions - Range Configuration DisplayTouch and hold the #1 keypad for 5 seconds.
  • Hidden Functions - Range Configuration Display (1 keypad)Touch and hold the #1 keypad for 5 seconds.
  • Hidden Functions - Sabbath Mode (6 keypad)Touch and hold the #6 keypad for 5 seconds (after oven has finished preheating in Bake mode).
  • Hidden Functions - Sell ModeTouch and hold the Timer Cancel keypad for 5 seconds.
  • Hidden Functions - Sell Mode (Timer Cancel keypad)Touch and hold the Timer Cancel keypad for 5 seconds.
  • Hidden Functions - Timer Operating Tones OffTouch and hold the Timer Start keypad for 5 seconds.
  • Hidden Functions - Timer Operating Tones Off (Timer Start keypad)Touch and hold the Timer Start keypad for 5 seconds.
  • Hidden Functions - Tone Frequency ChangeTouch and hold the #7 keypad for 5 seconds.
  • Hidden Functions - Tone Frequency Change (7 keypad)Touch and hold the #7 keypad for 5 seconds.
  • Non-Convection Freestanding/Slide-In Board ProgrammingAfter powering up the unit, press the following keypads in sequence
  • Non-Convection Freestanding/Slide-In Control ProgrammingAfter unit is powered up, press the following keypad sequence
  • Sabbath Mode["Press Bake","Enter desired temperature","Press Start and allow oven to preheat","When oven has…
  • User interface programming (after UI replacement)1

Full entry steps, exit procedures, and test sequences are available in Max.

Related Amana air conditioner models

75,000+ service documents · 20,000+ error codes · 100+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass