mypros+
Model reference

Amana 210W-3J

Air Conditioner

1 document22 error codes9 service modes

Available documentation

Other

  • W11082888 - Rev D64 pg
    Covers this model
MyPros+ Max

Diagnose your Amana 210W-3J.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (22)

CodeMeaning
F0E0No fault detected.F0E2Over suds condition detected; suds prevent basket from spinning up to speed or…F0E4High water temperature detected during rinse cycle (105°F or higher).F0E5Off balance load detected.F1E1Main control fault.F1E2Motor control faultF2E1Stuck keyF2E3Switch mismatchF3E1Pressure system faultF3E2Inlet water temperature faultF5E1Lid switch faultF5E2Lid lock faultF5E3Lid unlock faultF5E4Lid not opened between cyclesF7E1Basket speed faultF7E5Shifter faultF7E6Motor faultF7E7Motor unable to reach target RPMF8E1No fill / long fillF8E3Overflow conditionF8E5Hot and cold inlet hoses are reversed.F9E1Long drain

Service modes (9)

  • Automatic Test Mode["Activate Service Diagnostic Test Modes.","Turn the cycle selector knob until the 'Spin' LED is…
  • Calibration Mode["Activate Service Diagnostic Test Modes.","Turn the cycle selector knob until the 'Rinse' LED is…
  • Fault Code Display Mode["Activate Service Diagnostic Test Modes (see entry sequence above).","Turn the cycle selector knob…
  • Manual Test Mode["Activate Service Diagnostic Test Modes.","Turn the cycle selector knob until the 'Spin & Done'…
  • Service Diagnostic Test Mode Entry["Ensure washer is in standby mode (plugged in with all indicators off).","Wait 10 seconds after…
  • Service Diagnostic Test Modes (entry)["Ensure washer is in standby mode (plugged in with all indicators off). Wait 10 seconds after…
  • Software Version Display Mode["Activate Service Diagnostic Test Modes.","Turn the cycle selector knob until the 'Rinse, Spin…
  • Tachometer Verification Mode["Activate Service Diagnostic Test Modes.","Turn the cycle selector knob until the 'Wash and Done'…
  • UI Test Mode["Activate Service Diagnostic Test Modes.","Turn the cycle selector knob until the 'Rinse & Spin'…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Amana air conditioner models

75,000+ service documents · 20,000+ error codes · 100+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass