mypros+
Model reference

Amana 5P-2MW

Air Conditioner

1 document37 error codes19 service modes

Available documentation

Service Manual

  • Service Manual - RB41000127 pg
    Covers this model
MyPros+ Max

Diagnose your Amana 5P-2MW.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (37)

CodeMeaning
-F2-Membrane switch failure.-F6-Microwave relay failure.:Flashing colon on display indicates a power failure has occurred.E0No errors; functioning ice maker.E1No cooling; ice maker timed out; ice compartment unable to reach desired…E2Motor lost position; ice maker did not find home during harvest and exceeded…E3Heater time-out; ice mold heater was on longer than maximum allowable time…E4Ice bin not present or full (manufacturing error code).E5Bad ice maker thermistor; ice storage temperature satisfied but ice mold in…E6Dispenser UI EEPROM faulty (manufacturing error code).ErCommunication failure (manufacturing error code).F0E2Over suds condition detectedF0E4High water temperature detected during rinse cycle (105°F or higher).F0E5Off balance load detected during operation.F1E1Main control fault.F1E2Motor control faultF2Membrane switch (touch panel) failure.F2E1Stuck keyF2E3Mismatch of main control and UIF3E1Pressure sensor faultF3E2Inlet water temperature faultF3HHumidity sensor out of range.F3TTemperature sensor failure.F5E1Lid switch fault (lid up)F5E2Lid lock faultF5E3Lid unlock faultF5E4Lid not opened between cyclesF6Microwave relay failure.F7Power to magnetron interrupted.F7E1Basket speed sensor fault
View all 37 error codes
F7E5Shifter faultF7E6Motor faultF7E7Motor unable to reach target RPMF8E1No fill / long fillF8E3Overflow conditionF8E5Hot and cold inlet hoses are reversed.F9E1Long drain

Service modes (19)

  • Automatic Test Mode["Enter Service Diagnostic Test Modes.","Turn cycle selector knob until Spin LED is On (display…
  • Board Input TestRefer to Technical Sheet or Mini Manual packed behind Toe Panel.
  • Board Output TestRefer to Technical Sheet or Mini Manual packed behind Toe Panel.
  • Calibration Mode["Enter Service Diagnostic Test Modes.","Turn cycle selector knob until Rinse LED is On (display…
  • Child Lock["Ensure the microwave oven and Timer are off.","Touch and hold CANCEL for 5 seconds until 2 tones…
  • Demo Mode["Microwave oven and Timer must be off.","Touch and hold Timer for 5 seconds until two tones sound…
  • Fault Code Display Mode["Enter Service Diagnostic Test Modes.","Turn cycle selector knob until Done LED is On (display…
  • Manual Test Mode["Enter Service Diagnostic Test Modes.","Turn cycle selector knob until Spin & Done LEDs are On…
  • Self-Diagnostic Test Mode["1
  • Service Diagnostic Test Modes (Entry)["Ensure washer is in standby mode (plugged in with all indicators off).","RESET
  • Service Diagnostics Mode["Ensure refrigerator is not in lockout mode.","Press SW1 and SW2 simultaneously for 3…
  • Service ModeRefer to Technical Data Sheet located behind Toe Panel for entry procedure.
  • Software Version Display Mode["Enter Service Diagnostic Test Modes.","Turn cycle selector knob until Rinse, Spin, and Done LEDs…
  • Tachometer Verification Mode["Enter Service Diagnostic Test Modes.","Turn cycle selector knob until Wash and Done LEDs are On…
  • Touch Panel and Electronic Control Diagnostic Test["Press and hold CANCEL while opening the door.","While still holding the CANCEL button, unplug the…
  • Touch Panel and Electronic Control Self-Diagnostic Test["Press and hold CANCEL while opening the door.","While still holding the CANCEL button, unplug the…
  • Touch Panel and Electronic Control Self-Diagnostic Test Mode["Press and hold CANCEL while opening the door.","While still holding the CANCEL button, unplug the…
  • Touch Panel and Microcomputer Board Test (Self-Diagnostic)["Press and hold the OFF/CANCEL button while opening the door.","While still holding the OFF/CANCEL…
  • UI Test Mode["Enter Service Diagnostic Test Modes.","Turn cycle selector knob until Rinse & Spin LEDs are On…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Amana air conditioner models

75,000+ service documents · 20,000+ error codes · 100+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass