mypros+
Model reference

Amana 6P-5N/P54973-3R

Air Conditioner

2 documents122 error codes29 service modes

Available documentation

Tech Tip

  • Instruction Sheet - 818443020 pg
    Covers this model
  • Instruction Sheet - 818477712 pg
    Covers this model
MyPros+ Max

Diagnose your Amana 6P-5N/P54973-3R.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (122)

CodeMeaning
1-1Control detected K400 pilot relay stuck closed.1-2Damaged or corrupted memory on control board, or incompatible software…10-1Dispenser electrical problem10-2Vent wax motor electrical problem (not all models)10-3Drying fan error (on models with fan)12-1No communication between ECM and control12-2No link between ECM and wireless router12-3No link between ECM and Internet12-5Antenna B problem12-7Provisioning problem2-1Control detected stuck key(s) in keypad or keypad connection.2-2User interface cannot communicate with main control3-1Open connector or component in Temperature Sensing circuit3-2Incoming water temperature above 167°F (75°C), or shorted connection/component…3-3OWI calibration failure4-4Wash motor failure5-1Door stuck open5-2Door stuck closed6-1Low/no water (mechanical problem)6-2Fill valve electrical problem6-3Suds/air in pump6-4Float switch open6-6Cool water; incoming water temperature under 18°C/65°F.6-7Disconnected or damaged flowmeter.6-8Water softener regeneration valve electrical problem (water softener models…7-1No heat7-2Heater stuck on8-1Slow drain; obstructed drain hose or path; drain pump impeller fractured or…8-4Drain motor electrical problem9-1Diverter can't find position
View all 122 error codes
9-2Diverter stuck on9-3Diverter disc missing9-4Lower spray arm errorE1Ice maker harvest error reported during Door Ice Maker or Freezer Ice Maker…E2Ice maker harvest error reported during Door Ice Maker or Freezer Ice Maker…E3Ice maker harvest error reported during Door Ice Maker or Freezer Ice Maker…E4Ice maker harvest error reported during Door Ice Maker or Freezer Ice Maker…F0Default F codeF0 E0Default F codeF0-0No fault presentF1Keypad not connected, keypad held down too long, or keypad is shorted.F1 E0Door switch malfunction (E0, E1, E2) or electronic control malfunction (E3, E4).F1 E1Door switch malfunction (E0, E1, E2) or electronic control malfunction (E3, E4).F1 E2Door switch malfunction.F1 E3Electronic control malfunction.F1 E4Electronic control malfunction.F1-1Runaway cook condition in upper ovenF1-2Runaway cook condition in lower ovenF1-3Runaway clean condition in upper ovenF1-4Runaway clean condition in lower ovenF1-5Cancel keypad failure for upper oven.F1-6Cancel keypad failure for lower oven.F1-7Keypad disconnected from control.F1-8Keypad shorted.F1-9Slave communication failure.F1-AUpper oven latch switch failureF1-BLower oven latch switch failureF1-CUpper oven door open detected when it should be closed.F1-DLower oven door open detected when it should be closed.F1-EEEPROM failure on control board.F1-E0Control board resistor opened.F1-E1Control board resistor shorted.F1-FJumper configuration error on control board.F1-HEEPROM read error on control board.F1-LSensor wire open or brokenF10E1Dispenser electrical problem; loose connection in Dispenser circuit and/or open…F10E2Vent wax motor electrical problem; loose connection in Vent circuit and/or open…F10E3Drying fan error; loose connection in Fan circuit and/or open fan motor (on…F1E1Control detected K400 pilot relay stuck closed.F1E2Damaged or corrupted memory on control board; incompatible software components…F2Keypad failure or electronic control malfunction.F2 E0Keypad not connected or keypad held down too long or keypad is shorted.F2 E1Keypad held down too long, or keypad is shorted.F2-E3Electronic control malfunction.F2E1Control detected stuck key(s) in keypad or keypad connection.F2E2User interface cannot communicate with main control; loose user interface…F3 E0Control board resistor opened.F3 E1Control board resistor shorted.F3 E2Convection sensor malfunction.F3-1Upper oven sensor open or shorted.F3-2Lower oven sensor open or shorted.F3-E0Convection sensor malfunction.F3-E2Convection sensor malfunction.F3E1Open connector or component in Temperature Sensing circuit; open or faulty…F3E2Shorted connection or component in Temperature Sensing circuit; incoming water…F3E3OWI calibration failure.F4 E0Meat probe shorted.F4-E0Door switch malfunction (function not used).F4-E1Door switch malfunction (function not used).F4-E2Door switch malfunction (function not used).F4E4Wash motor failure; loose connection in Wash Motor circuit and/or open wash…F5E1Door stuck open; door was not latched within 3 seconds of pressing Start/Resume…F5E2Door stuck closed; control programmed to not start if it suspects the door…F6E1Low/no water to dishwasher (mechanical problem).F6E10Water tank valve stuck open; contaminant in valve or valve mechanically…F6E2Fill valve electrical problem; loose connection in Fill Valve circuit and/or…F6E3Suds/air in pump detected.F6E4Float switch stuck in overfill (open) position and/or dishwasher not level.F6E9Water tank valve not functioning; loose connection in valve circuit and/or open…F7E1No heat; control programmed to disable heater due to detected water heating…F7E2Heater stuck on; heater drive circuit on the control.F8Meat probe shorted (function not used).F8 E0Self-clean latch will not lock.F8 E1Self-clean latch will not unlock.F8 E3Electronic control malfunction.F8E1Slow drain; obstructed drain hose or path.F8E2Drain pump impeller fractured.F8E3Not explicitly listed but referenced in troubleshooting as drain motor related…F8E4Drain motor electrical problem; loose connection in Drain Motor circuit and/or…F9-1Upper oven latch switch error during locked state.F9-2Upper oven unlock switch error during locked state.F9-3Upper oven lock and unlock switch both in error.F9-4Lower oven lock switch error during locked state.F9-5Lower oven unlock switch error during locked state.F9-6Lower oven lock and unlock switch both in error.F9E1Diverter can't find position; corroded or loose connection in Diverter…F9E2Diverter stuck on; diverter drive circuit on the control.F9E3Diverter disk in sump is missing.F9E4Lower spray arm error; mechanical binding or blocking of spray arm, or…IBIce maker harvest test indicates the ice bin is full.OPThermistor is open circuit (displayed during thermistor service tests).SHThermistor is shorted (displayed during thermistor service tests).

Service modes (29)

  • Clear Customer Error HistoryDuring interval 25 of the Service Diagnostics Cycle, press the Hi Temp key to clear customer error…
  • Control LockoutPress Setup and then 4
  • control_lockoutPress Setup, then press 4
  • Demo ModePress Bake and Cancel keys for 3 seconds.
  • demo_modePress Bake and Cancel keys simultaneously for 3 seconds.
  • diagnostic["If the 'Drawer,' 'Fridge,' or 'Freezer' key is selected, de-select the selected zone to…
  • Diagnostics (Service Test Mode)["If the 'Drawer', 'Fridge', or 'Freezer' key is selected (lit), de-select it to extinguish the…
  • Engineering ModePress the Bake Key of either oven, enter a bake temperature of 100°F, then hold Bake down for 3…
  • engineering_modePress the Bake key of either oven, enter a bake temperature of 100°F, then hold Bake down for 3…
  • Error code display["Press and hold the CANCEL key for 5 seconds to display any pre-existing fault code.","The failure…
  • Lockout Mode (RFS9MP2/RFS10MP2/RFS11MP2)["Open and close the oven door
  • Optional Programs Mode (RFS8B/RFS9B/RFS9LW/RFS10B/RFS11B/RFS11LW)["Open the oven door
  • Oven Temperature AdjustPress Bake in either upper or lower oven, enter a temperature of 550°F, then hold Bake key for 3…
  • oven_temperature_adjustPress Bake in either upper or lower oven, enter a temperature of 550°F, then hold Bake key for 3…
  • Preset Times Programming Mode (RVS7/RFS8/RFS8SE/RFS8SW/RFS10/RFS10SE/RVS10)["Open and close the oven door
  • Programming Mode (RCS720A/RCS720B/RCS820BL/RCS820LW/RVS10A/RVS10B/RVS11B)["Open the oven door
  • Programming Mode (RCS720MP/RCS820MPB/RCS820MPLW/RFS8MP/RFS8MPK/RFS8SW1/RFS9MP/RFS9MPK/RFS9MPLW/RFS9SW2/RFS10MP/RFS11MPLW/RFS11SW2)["Open the oven door
  • Programming Mode (RFS8B/RFS9B/RFS9LW/RFS10B/RFS11B/RFS11LW)["Open the oven door
  • Programming Mode (RFS9MP2/RFS10MP2/RFS11MP2)["Open the oven door
  • Programming Options Mode (RVS7/RFS8/RFS8SE/RFS8SW/RFS10/RFS10SE/RVS10)["Open and close the oven door
  • Rapid Advance (Customer Cycle)After starting a customer cycle, press HIGH TEMP
  • Rapid Advance Mode (Customer Cycles)After starting the customer cycle, press HIGH TEMP
  • Rapid Advance Mode (during active cycle)After starting a cycle, press HI TEMP
  • Review Preprogrammed Heating Times (RCS720MP/RCS820MPB/RCS820MPLW/RFS8MP/RFS8MPK/RFS8SW1/RFS9MP/RFS9MPK/RFS9MPLW/RFS9SW2/RFS10MP/RFS11MPLW/RFS11SW2)["Open the oven door
  • Sales Demo Mode ClearRun Service Diagnostics Cycle to clear demo mode.
  • Service Diagnostic CycleWith dishwasher in standby, press any 3 keys in the sequence 1-2-3, 1-2-3, 1-2-3 with no more than…
  • Service Diagnostics CycleWhile in standby, press any 3 keys in the sequence 1-2-3-1-2-3-1-2-3 with no more than 1 second…
  • Test ModeHold Cancel and Broil keys down for 3 seconds within 5 minutes of power up
  • test_modeHold Cancel and Broil keys down simultaneously for 3 seconds

Full entry steps, exit procedures, and test sequences are available in Max.

Related Amana air conditioner models

75,000+ service documents · 20,000+ error codes · 100+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass