Model reference
Amana 75A-256
Air Conditioner
2 documents36 error codes10 service modes
Available documentation
Tech Tip
- instructionsheet-w10108050.pdf2 pg
- Instruction Sheet - 82035452 pg
MyPros+ Max
Diagnose your Amana 75A-256.
- Step-by-step diagnostics from the service manual
- Test values, resistance specs, and wiring references
- Verified part numbers when replacement is needed
Start diagnosing
$29/month · Cancel anytime · Or $9.95 3-day pass
Error codes (36)
CodeMeaning
1Dryer Thermistor Short Sensed10No Wet Clothes2Thermistor Open Sensed3Door Circuit Failure4Possible motor transistor error8Stuck KeydCDoor Circuit FailuredoDoor OpenF0Default F codeF1Electronic control malfunction.F1 E0EEPROM communications error.F1 E1EEPROM checksum failure.F1 E2UL A/D error(s).F1-E0Key held down too long or key is shorted.F1-E1Keypad keytail not connected.F1-E5CANCEL key drive line open.F1-E6CANCEL key drive line open.F2 E0Shorted key detected on keypad.F2 E1Keytail unplugged from control board.F2-E0Temperature sensor opened (R=2875 ohm by spec).F2-E1Temperature sensor shorted (R=825 ohm by spec).F2-E2Oven temp too highF2-E3Oven temp too highF3 E0Oven temperature sensor opened (open circuit).F3 E1Oven temperature sensor shorted.F3 E2BAKE/BROIL range over temperature condition.F3 E3CLEAN range over temperature condition.F3-E0Door is open but latch is locked (door switch indicates open door, latch switch…F3-E1Self-clean latch will not lock/unlock.F5Door latch or switch system failure (related to latch assembly, motor, door…Service modes (10)
- Bake Temperature Offset AdjustmentPress BAKE pad for 5 seconds
- Diagnostic Code DisplayEnter Service Mode, then press Wrinkle Prevent
- Fahrenheit to Celsius ConversionPress the BROIL pad for 5 seconds
- Last Error Code RecallPress and hold the CANCEL/OFF key for 5 seconds until last error code is displayed.
- LED/Switch CheckWhile in Service Mode, press Chime and Wrinkle Prevent keys for 3 seconds to start the LED/Switch…
- Programming Cavity SizeWithin 60 seconds of power up, press the following touchpads in order
- Service ModeDryer must be on
- Software Revision DisplayWhile in Service Mode, press the Temperature key to display the software revision number.
- System Check ModeWhile in Service Mode, press the Time and Wrinkle Prevent keys for 3 seconds. 'in' will display…
- Test Mode (Diagnostic)Press CANCEL, CANCEL, START within 60 seconds of power up.
Full entry steps, exit procedures, and test sequences are available in Max.
Related Amana air conditioner models
75,000+ service documents · 20,000+ error codes · 100+ brands
Get Started$29/month · Cancel anytime · Or $9.95 3-day pass