Model reference

Amana 7P-2GM

Air Conditioner

29 error codes5 service modes

MyPros+ Max

Diagnose your Amana 7P-2GM.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (29)

CodeMeaning

:Flashing colon indicates a power failure has occurred.1-1Control detected K1 pilot relay stuck closed.1-2Control software issue 10-1Dispenser electrical problem 2-1Control detected stuck key(s) in keypad or keypad connection.3-1Open connector or component in Temperature Sensing circuit, or open/faulty…3-2Shorted connection or component in Temperature Sensing circuit, shorted/faulty…3-3OWI failed calibration, possibly due to OWI failure or drain hose check valve…4-3Wash motor not running due to loose connection in Motor circuit, faulty wash…5-1Door stuck open 5-2Door stuck closed 6-1Low or no water 6-2Fill valve electrical problem 6-3Suds or air in pump 6-4Float switch open 6-5Fill valve triac on control shorted, fill valve mechanically stuck open, too…6-6Incoming water temperature under 84°F (29°C)7-1No heat 7-2Heater stuck on 8-1Slow drain 8-2Drain motor electrical problem 8-3Drain stuck on 9-1Diverter problem.9-2Diverter problem.F2Touch panel failure.F3HHumidity sensor failure.F6MW relay failure (Relay 4903 contact may have welded closed).NTC OPEN, CALL FOR SERVICEHF NTC thermistor is open.NTC SHORT, CALL FOR SERVICEHF NTC thermistor is shorted.

Service modes (5)

Clear Customer Error HistoryDuring Service Diagnostics Cycle interval where Cycle 2 and Hi Temp LEDs flash, press Cycle Select…
Rapid Advance Mode (Customer Cycles)After starting a customer cycle, press HIGH TEMP
Self-diagnostic test mode["Press and hold the STOP/CLEAR button while opening the door.","While still holding the STOP/CLEAR…
Service Diagnostics CycleWhile in standby, press any 3 keys in the sequence 1-2-3-1-2-3-1-2-3 with no more than 1 second…
Touch Panel and PCBA Self-Diagnostic Test Mode["Press and hold the STOP/CLEAR button while opening the door.","While still holding the STOP/CLEAR…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Amana air conditioner models

75,000+ service documents · 20,000+ error codes · 100+ brands

$29/month · Cancel anytime · Or $9.95 3-day pass