mypros+
Model reference

Amana ERHQ48-001A/P55201-95C

Air Conditioner

15 error codes17 service modes
MyPros+ Max

Diagnose your Amana ERHQ48-001A/P55201-95C.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax

Error codes (15)

CodeMeaning
13EMAIN PCB signal not detected for 10 seconds.3EMotor failure4EWater level sensor fault5ENo drain8EMotor faultCEWater temperature faultdoorDoor is open and washer is paused.HE1Heater is over heatingHE2Heater is not heatingIEPressure switch errorLENo fillOEWater sensor level faultPFPower failuretESump thermistor failureUEUnbalance detected during final spin

Service modes (17)

  • Abbreviated White/Cottons Cycle TestWhile in Service Mode, press Delay Start (four times) followed by Start/Pause button.
  • Board Output Test - LED/Switch TestEnter Board Output Test, then press the Temperature key three times followed by the Start/Pause…
  • Board Output Test - Motor Output TestEnter Board Output Test, then press the Temperature key twice followed by the Start/Pause button
  • Board Output Test - Valve/Pump/Heater CycleEnter Board Output Test, then press the Temperature key once followed by the Start/Pause button…
  • Board Output Test (Component Cycle Time Test)While in Service Mode, press the Temperature key (Once) followed by the Start/Pause button
  • Board Output Test (EEPROM Test)Press and hold the Rinse, Prewash and Delay Start buttons, followed by the Power On/Off switch
  • Board Output Test (EEPROM)Press and hold the Rinse, Prewash, and Delay Start buttons, then press the Power Off switch
  • Component TestWhile in Service Mode, press the Start/Pause button to cycle through
  • EEPROM Test (Board Output Test)Press and hold the Rinse, Prewash and Delay Start buttons, then press the Power On/Off switch
  • LED/Switch TestEnter the Board Output Test, then press the Temperature key (three times) followed by Start/Pause…
  • Motor Output TestEnter the Board Output Test, then press the Temperature key (twice) followed by Start/Pause button
  • Rinse And Spin TestWhile in Service Mode, press Delay Start (seven times) followed by Start/Pause button
  • Service Mode1
  • Spin TestWhile in Service Mode, press Delay Start (six times) followed by Start/Pause button
  • Thermistor TestWhile in Service Mode, press Delay Start (two times) followed by Start/Pause button
  • Unbalance TestWhile in Service Mode, press Delay Start (three times) followed by Start/Pause button
  • White/Cottons Cycle TestWhile in Service Mode, press Delay Start (five times) followed by Start/Pause button.

Full entry steps, exit procedures, and test sequences are available in Max.

Related Amana air conditioner models

75,000+ service documents · 20,000+ error codes · 100+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax