mypros+
Model reference

Amana SMC-1-A

Compactor

3 documents22 error codes10 service modes

Available documentation

Installation Guide

  • Installation Instructions7 pg
    Covers this model
  • Installation Instructions7 pg
    Covers this model
  • Installation Instructions5 pg
    Covers this model
MyPros+ Max

Diagnose your Amana SMC-1-A.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (22)

CodeMeaning
F0E2Over suds condition detectedF0E4High water temperature detected during rinse cycleF0E5Off balance load detected.F1E1Main control fault.F1E2Motor control faultF2E1Stuck keyF2E3Mismatch of main control and UIF3E1Pressure sensor faultF3E2Inlet water temperature faultF5E1Lid switch faultF5E2Lid lock faultF5E3Lid unlock faultF5E4Lid not opened between cyclesF7E1Basket speed sensor faultF7E5Shifter faultF7E6Motor faultF7E7Motor unable to reach target RPMF8E1Long fillF8E3Overflow conditionF8E5Hot and cold water supply hoses reversed.F8E6No fillF9E1Long drain

Service modes (10)

  • Calibration Mode["Activate Service Diagnostic Test Modes.","Toggle cycle selector knob until only the RINSE LED is…
  • Clean Washer Cycle["Activate Service Diagnostic Test Modes.","Toggle cycle selector knob until SOAK/WASH, RINSE, and…
  • Drain and Spin Cycle["Activate Service Diagnostic Test Modes.","Toggle cycle selector knob until RINSE and DONE LEDs…
  • Fault Code Display Mode["Activate Service Diagnostic Test Modes (see entry sequence above).","Toggle cycle selector knob…
  • Manual Overview Test Mode["Activate Service Diagnostic Test Modes.","Toggle cycle selector knob until FINAL SPIN and DONE…
  • Quick Overview Test Mode["Activate Service Diagnostic Test Modes.","Toggle cycle selector knob until only the FINAL SPIN…
  • Service Diagnostic Test Modes (Entry)["Ensure washer is in standby mode (plugged in with all indicators off).","Place cycle selector…
  • Software Version Display Mode["Activate Service Diagnostic Test Modes.","Toggle cycle selector knob until RINSE, FINAL SPIN, and…
  • Tachometer Verification Mode["Activate Service Diagnostic Test Modes.","Toggle cycle selector knob until SOAK/WASH and DONE…
  • UI Test Mode["Activate Service Diagnostic Test Modes.","Toggle cycle selector knob until RINSE and FINAL SPIN…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Amana compactor models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass