Model reference
Amana EPHO6000-3A/P67220-9C
Furnace
25 error codes12 service modes
MyPros+ Max
Diagnose your Amana EPHO6000-3A/P67220-9C.
- Step-by-step diagnostics from the service manual
- Test values, resistance specs, and wiring references
- Verified part numbers when replacement is needed
Start diagnosing
$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax
Error codes (25)
CodeMeaning
2-1Key switch stuck closed for more than 30 seconds.2-2Over temperature alarm.2-3Long black out alarm.2-4Door alarm.3-1Fridge evaporator sensor issue.3-2Fridge ambient sensor issue.3-3Freezer ambient sensor issue.4-1Heater failure.F1E1Indicates a Cycle Control Unit (CCU) problem.F2E1Indicates a stuck button (depressed for over 20 seconds) or UI mismatch; only…F2E2User Interface software errorF3E1Exhaust thermistor is open; temperature drops below 18°F (>50k ohms).F3E2Exhaust thermistor has shorted; temperature above 250°F (<500 ohms).F3E3Inlet thermistor is open; temperature drops below 18°F (>245k ohms).F3E4Inlet thermistor is shorted; temperature above 391°F (<20 ohms).F3E5Inlet and exhaust thermistors are open; will occur if P14 connector is not…F3E6Moisture sensor strip is open; only appears in service diagnostic mode.F3E7Moisture sensor strip has shorted; only appears in service diagnostic mode.F4E1No voltage detected at the heater relay; only appears in service diagnostic…F4E3Restricted/low air flow that may affect dryer performance.F4E4Low L2 voltage (less than 50V) detected at installation.F6E1Communication error from UI to CCU; communication between CCU and UI has not…F6E2Communication error from CCU to UI; communication between CCU and UI has not…L2Low L2 voltage (less than 50V) detected at installation.PFPower failure occurred while the dryer was running.Service modes (12)
- Customer-Focused Dryness Level Adjustment1
- diagnosticStandby Method
- diagnostic_alternative1) Unplug the refrigerator. 2) Wait 20 seconds. 3) Plug back in. 4) Within 30 seconds, press…
- failure_historyEntered automatically after KEY test
- Install Diagnostics1
- key_testAutomatically enters after service test activation
- Loads Test Mode["Ensure dryer is in standby mode (plugged in with all indicators off).","Within 5 seconds
- loads_and_sensor_testEntered after failure history step
- Service Diagnostic Mode1. Ensure dryer is in standby mode (plugged in with all indicators off). 2. Select any three…
- Software Version Display1
- User Interface Test1
- User Interface/Control System Test1. Activate Service Diagnostic Mode. 2. Press and release the 1st button used to activate Service…
Full entry steps, exit procedures, and test sequences are available in Max.
Related Amana furnace models
75,000+ service documents · 20,000+ error codes · 100+ brands
Get Started$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax