Model reference

Amana GC80DJ-3/P96455-3F

Furnace

5 documents26 error codes2 service modes

Available documentation

Tech Tip

Instruction Sheet - 396846915 pg
Covers this model
Instruction Sheet - 818472212 pg
Covers this model

Installation Guide

Installation Instructions6 pg
Covers this model
Installation Instructions6 pg
Covers this model
Installation Instructions38 pg
Covers this model

MyPros+ Max

Diagnose your Amana GC80DJ-3/P96455-3F.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Amana Furnace

1-1 on my Amana GC80DJ-3/P96455-3F

M+

Control detected K2 pilot relay stuck

From Tech Sheet W14785730, p.22:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure control board supply voltage at test points. Expected: 12 VDC and 5 VDC.

3.Inspect all connectors on the main control for corrosion or backed-out pins.

Part WPW10804018

Electronic control board

Error codes (26)

CodeMeaning

1-1Control detected K2 pilot relay stuck closed.1-2Damaged or corrupted memory on control board, or incompatible software…10-1Dispenser electrical problem 10-3Drying fan error 2-1Control detected stuck key(s) in keypad or keypad connection.2-2User interface cannot communicate with main control 3-1Open connector or component in temperature sensing circuit (open or faulty…3-2Shorted connection or component in temperature sensing circuit, shorted or…3-3OWI calibration failure due to OWI sensor failure or drain hose check valve not…4-3Wash motor not running due to loose connection in motor circuit, faulty wash…5-1Door stuck open 5-2Door stuck closed 6-1Low or no water 6-2Fill valve electrical problem 6-3Suds or air in pump causing repeated wash periods.6-4Float switch open 6-7Disconnected or damaged flowmeter.6-8Regen valve electrical problem 7-1No heat 7-2Heater stuck on 8-2Drain motor electrical problem 8-3Drain motor stuck on 9-1Diverter can't find position 9-2Diverter stuck on 9-3Diverter disk in sump is missing.9-4Lower spray arm error

Service modes (2)

Rapid Advance Mode (Customer Cycles)After starting a customer cycle, press HIGH TEMP
Service Diagnostics CycleWhile in standby, press any 3 keys in the sequence 1-2-3-1-2-3-1-2-3 with no more than 1 second…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Amana furnace models

78,000+ service manuals · 160,000+ error codes · 55+ brands

$29/month · Cancel anytime · Or $9.95 3-day pass