Amana CC-3/P27271-3S

Error codes (26)

Service modes (30)

• Clean Washer Cycle["Enter Diagnostic Mode (display is flashing).","Press BRIGHTS button to start the Clean Washer…
• Code Display Sub-mode["Open the service door.","The current F or d code is displayed (only accessible when washer is in…
• Credit a Cycle["Enter Diagnostic Mode (display is flashing).","Press PERM
• Damp Dry Test["Begin with an empty dryer and clean lint screen.","Set Timer to DAMP DRY.","Set Fabric…
• damp_dry_test["Begin with a fully assembled, empty dryer with clean lint screen connected to known good power…
• diagnostic["Enter set-up mode first.","Navigate to set-up code 6 (or dAS display if operating with Maytag…
• Diagnostic Mode (Blink Mode)["First access Setup/Configuration Mode.","Press DELICATES & KNITS button for 1 second while one of…
• Diagnostic Mode (Washer Diagnostic Mode)["Press 'Start Operating Set-up' button to enter setup mode.","Press and hold DELICATES AND KNITS…
• diagnostic_test["Set Fabric Care/Temperature switch to AIR FLUFF","Set Signal switch to HIGH","Set Timer to TIMED…
• Factory Test["Open the door.","Set Fabric Care/Temperature switch to AIR FLUFF.","Set Signal switch to…
• help["Enter set-up mode first.","Navigate to set-up option 2.XX (or dAS display if operating with…
• Help Mode["PD models
• Help Mode (dAS mode)1
• Help Mode (PD models)1
• Manual Overview Test["Enter Flashing Mode (diagnostic mode with entire display flashing).","Press the WHITES button."]
• Quick Drain and Spin["Enter Diagnostic Mode (Blink Mode).","Press COLORS button while the display is blinking."]
• Quick Overview Test["Enter Flashing Mode (diagnostic mode with entire display flashing).","Press the DELICATES AND…
• Quick Spin Cycle["Enter Diagnostic Mode (display is flashing).","Press COLORS button to start the Quick Spin…
• Service Access Code (free-vend models only)1. Open the door. 2. Within 10 seconds, press in sequence
• Service Access Code (PN Models without key switch)["Only functions on washers set up for 0 vend price without any Special Pricing set-up, and…
• Service Diagnostic Test Modes1. Disconnect power and remove service door (PD models) or remove AA1 jumper from IU control board…
• setup["PD Models: Insert access door key, turn, and lift to remove access door.","PN/PR Models (Option…
• Setup Mode (PD Models)["Insert service access door key, turn, and lift to remove access door.","Use DELICATES AND KNITS…
• Setup Mode (PN Models)["Unplug washer or disconnect power.","Open console, disconnect plug on AA1, close console.","Plug…
• Setup/Configuration Mode["PD models
• Setup/Configuration Mode (PD models)Insert key into service access door, turn and lift to remove the service access door.
• Setup/Configuration Mode (PR models)Insert setup card (from card reader manufacturer) into card reader
• Setup/Programming Mode["For coin-operated models
• Washer Cleaning Program["Enter Diagnostic Mode (Blink Mode).","Press BRIGHT button while the display is blinking."]
• Washer Diagnostic Mode["First enter 'Start Operating Set-Up' (setup mode).","Press and hold the QUICK CYCLE button for 1…

Full entry steps, exit procedures, and test sequences are available in Max.