mypros+
Model reference

Amana R-1H

Range

58 error codes5 service modes
MyPros+ Max

Diagnose your Amana R-1H.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (58)

CodeMeaning
:Flashing colon indicates a power failure has occurred.1-1Control detected K400 pilot relay stuck closed.1-2Control software issue10-1Dispenser electrical problem10-2Vent wax motor electrical problem (not all models)10-3Drying fan error (on models with fan)12-1No communication between ECM and control12-2No link between ECM and wireless router12-3No link between ECM and Internet12-5Antenna B problem12-7Provisioning problem2-1Control detected stuck key(s) in keypad or keypad connection.2-2No response from UI3-1Thermistor/OWI open3-2Thermistor/OWI shorted3-3OWI failed calibration4-4Wash motor failure5-1Door stuck open5-2Door stuck closed6-1Low/No water (mechanical problem)6-2Fill valve electrical problem6-3Suds/air in pump6-4Float switch open6-7Flowmeter disconnected or damaged.6-8Water softener regeneration valve electrical problem (water softener models…7-1No heat7-2Heater stuck on8-4Drain motor electrical problem9-1Diverter can't find position9-2Diverter stuck on
View all 58 error codes
9-3Diverter disc missing9-4Lower spray arm errorF1-E1Control detected K2 pilot relay stuck closed.F1-E2Control software issueF10-E1Dispenser electrical problemF10-E3Drying fan errorF2Touch panel failure.F2-E1Control detected stuck key(s) in keypad or keypad connection.F3-E1Open connection or component in temperature sensing circuit; open or faulty…F3-E2Shorted connection or component in temperature sensing circuit; incoming water…F3-E3OWI failed calibration.F3HHumidity sensor failure.F4-E3Wash motor not runningF5-E1Door stuck openF5-E2Door stuck closedF6MW relay failure (Relay 4903 contacts may have welded closed).F6-E1Low/no water (mechanical problem)F6-E2Fill valve electrical problemF6-E3Suds/air in pumpF6-E4Float switch openF6-E7Flowmeter disconnected or damaged.F6-E8Water softener regen valve electrical problemF7-E1No heatF7-E2Heater stuck onF8-E1Slow drainF8-E2Drain motor electrical problemF8-E3Drain stuck onF9-E1Disconnected or damaged flowmeter.

Service modes (5)

  • Customer Cycle Rapid Advance["Start a customer cycle.","Press HIGH TEMP
  • Rapid Advance (Customer Cycle)["Start a customer cycle.","Press HIGH TEMP
  • Service Diagnostic Cycle["Press START/RESUME to wake up the control panel.","Press any 3 keys in the sequence…
  • Service Diagnostics Cycle["Press START/RESUME to wake up control panel.","Press any three keys in the sequence…
  • Touch Panel and PCBA Self-Diagnostic Test Mode["1

Full entry steps, exit procedures, and test sequences are available in Max.

Related Amana range models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass