Model reference
Amana RCC-3
Range
5 documents19 error codes6 service modes
Available documentation
Service Manual
- ADC AD-75THS ServiceManual-PH5 PastProduction OPL73 pg
- Technical Education Job Aid 4317323 KAC-28 Electric Built-in Single Oven60 pg
Installation Guide
- Installation Instructions4 pg
- Installation Instructions26 pg
Other
- ELECTRIC COOKTOP Use & Care Guide28 pg
MyPros+ Max
Diagnose your Amana RCC-3.
- Step-by-step diagnostics from the service manual
- Test values, resistance specs, and wiring references
- Verified part numbers when replacement is needed
Start diagnosing
$29/month · Cancel anytime · Or $9.95 3-day pass
Error codes (19)
CodeMeaning
dOOrDoor switch circuit is open, either due to keyboard entry made while main door…dSFLFault detected in the microprocessor temperature sensor circuit; buzzer will…F0Default F codeF1Electronic control malfunction (all E codes).F2 E0Key held down too long, or key is shorted.F2 E1Keypad keytail not connected.F2 E5Cancel key drive line open.F3 E0Temperature sensor opened.F3 E1Temperature sensor shorted.F3 E2Oven temperature too high (over 301°C / 575°F in Cook mode).F3 E3Oven temperature too high (over 510°C / 950°F in Clean mode).F4 E1Meat probe malfunctionF5 E0Door is open but latch is locked (door switch closed indicating open door, and…F5 E1Self-clean latch will not lock.F5 E5Self-clean temperature (288°C / 550°F) not reached within 45 minutes.F5 E7Self-clean latch will not unlock.F6 E0Return line not connected; electronic control will display F6 within 60 seconds…HotPossible overheating condition detected; the microprocessor controller has…SEFLRotational sensor circuit failure indicating a fault in the basket (tumbler)…Service modes (6)
- Fahrenheit to Celsius conversionPress the BROIL pad for 5 seconds
- Fault code history recallPress and hold the '0' touchpad for 5 seconds to access the previous fault codes
- Hot condition manual resetAfter temperature drops to 220°F or lower, manually close and then open the program switch (PS) on…
- Phase 5 Coin System DiagnosticsThe Phase 5 coin microprocessor controller automatically monitors all major circuits including…
- Programming the cavity sizeWithin 60 seconds of power up, press the following touchpads in order
- Sabbath Mode exitIf 'SAB' appears in the display, press and hold the '6' touchpad for 5 seconds to end Sabbath Mode.
Full entry steps, exit procedures, and test sequences are available in Max.
Related Amana range models
78,000+ service manuals · 160,000+ error codes · 55+ brands
Get Started$29/month · Cancel anytime · Or $9.95 3-day pass