mypros+
Model reference

Amana SR19C-A-P73900-1WA

Refrigerator

3 documents41 error codes20 service modes

Available documentation

Tech Sheet

  • Tech Sheet - W10918869 - Rev E6 pg
    Covers this model
  • Tech Sheet - W10918869 Rev E6 pg
    Covers this model
  • Tech Sheet W10918869D6 pg
    Covers this model
MyPros+ Max

Diagnose your Amana SR19C-A-P73900-1WA.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (41)

CodeMeaning
d13Coin 2 errord16Generation 2 debit card reader errord5Coin 1 errord9Low voltage detection errorF01CCU errorF11MCU errorF1E0EEPROM communication error within the oven control.F1E5Sensor out of range.F1E7PCB thermistor open or shorted.F20No water detected entering washerF21Long drainF22Door lock errorF24Temperature sensor errorF25Tachometer errorF26Door switch errorF27Overflow conditionF28Communication failure between CCU and MCU.F29Door unlock errorF2E0Keypad disconnected from oven control.F2E1Stuck key detected on keypad.F2E2Cancel key error.F31Overheating of motorF33Pump disconnectedF34Load detected in washer during Washer Cleanout Cycle.F3E0Refrigerator/Main compartment (Z1) thermistor short or open circuit.F3E1Freezer/Main compartment (Z1) thermistor short or open circuit.F3E2Refrigerator Evaporator thermistor short or open circuit.F3E3Freezer Evaporator thermistor short or open circuit.F3E4Deli compartment (Z2) thermistor short or open circuit.F3E5Crisper (Z3) thermistor short or open circuit.
View all 41 error codes
F5E0Door and switches do not agree (Clean modeF6E1Over temperature during cook mode.F6E2Over temperature during clean mode.F6E3Over temperature in warming drawer.F70Communication failure between CCU and UIC (User Interface Control).F73UIC failureF74UIC failureFDE0Ice maker tray thermistor short or open circuit.FDEAIce Maker Jammed (cannot find Homing or end of harvest location).OPOpen circuit detected on thermistor.SHShort circuit detected on thermistor.

Service modes (20)

  • Auto TestEnter Diagnostics Mode (CANCEL > CANCEL > START), then press the up arrow, '+' key, or '3' key to…
  • Code Display Mode["This mode can be accessed only when the washer is in error state.","PD Models
  • Diagnostics Mode (MRC Control)Press CANCEL > CANCEL > START
  • DISPLAYEnter Diagnostics Mode (CANCEL > CANCEL > START), scroll to service mode 5 (DISPLAY).
  • ENG MODEEnter Diagnostics Mode (CANCEL > CANCEL > START), scroll to service mode 2 (ENG MODE)
  • FAULTSEnter Diagnostics Mode (CANCEL > CANCEL > START), scroll to service mode 7 (FAULTS).
  • Flashing Mode["PD Models
  • Help Mode (dAS Mode)["Open the service door or insert a manual diagnostic card.","The message dAS will appear in the…
  • Help Mode (PD Models)["Open the service door.","Press the DELICATES AND KNITS button until the display reads…
  • RELAY USAGEEnter Diagnostics Mode (CANCEL > CANCEL > START), scroll to service mode 8 (RELAY USAGE).
  • Service Access Code (PN Models without key switch)["Only functions on washers set up for 0 vend price without any Special Pricing, and Coin/Debit…
  • Service Diagnostics Mode["Press the pulsing JennAir logo to wake up the UI.","Press the middle zone key.","Press CONNECT…
  • Set-Up Mode (PD Models)["Insert service access door key, turn, and lift to remove access door.","The washer enters set-up…
  • Set-Up Mode (PN Models via AA1 connector)["Unplug washer or disconnect power.","Open console, disconnect plug on AA1, close console.","Plug…
  • Temperature AdjustmentPress OVEN LIGHT for 5 seconds
  • TEST MODEEnter Diagnostics Mode (CANCEL > CANCEL > START), scroll to service mode 3 (TEST MODE)
  • TEST ON (Relay Checks)Enter Diagnostics Mode (CANCEL > CANCEL > START)
  • USAGEEnter Diagnostics Mode (CANCEL > CANCEL > START), then scroll to service mode 1 (USAGE).
  • VERSIONEnter Diagnostics Mode (CANCEL > CANCEL > START), scroll to service mode 4 (VERSION).
  • Washer Diagnostic Mode["First enter 'Start Operating Set-Up' mode.","Press and hold the QUICK CYCLE button for 1 second…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Amana refrigerator models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass