Model reference
Cont Girbau H2130
Washer
6 documents25 error codes8 service modes
Available documentation
Service Manual
- Operation Instructions Handbook for Washers Control Version PM135 pg
Bulletin
- Kit of forced Ventilation HS-4040/HS-4055 (H2090/H2130)1 pg
- Engineering bulletin no.3191 pg
- Engineering Bulletin 3201 pg
Installation Guide
- Installation and Operation Instructions Handbook for Washers78 pg
- Installation Instructions Handbook for Washers70 pg
MyPros+ Max
Diagnose your Cont Girbau H2130.
- Step-by-step diagnostics from the service manual
- Test values, resistance specs, and wiring references
- Verified part numbers when replacement is needed
Start diagnosing
$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax
Error codes (25)
CodeMeaning
ALM/A-1Emergency stop activated.ALM/A-10Faulty cold water supply or faulty synthetics cooling.ALM/A-11Blocked duct or drain valve, or failure on water exhaust system.ALM/A-12Motor overheating.ALM/A-13Failure on door lock.ALM/A-2Faulty out-of-balance detection system (H machines).ALM/A-3Faulty temperature probe.ALM/A-4Water level detected with machine OFF; bath level sensor out of adjustment.ALM/A-5Door open or faulty door lock.ALM/A-6Faulty water supply or faulty water inlet.ALM/A-7Persistent over-level of water.ALM/A-8Faulty heating system.ALM/A-9Too high water temperature.ALM/COMPossible failure of inverter.ENd/BALFinal extract cancellation due to persistent out-of-balance (H machines).ENd/REdEnd of cycle with extract speed reduced due to out-of-balance in load.Err/1Washer model configuration error, Error in EPROM, or Plug X10 disconnection.Err/2Error in EPROM or RAM memory incorrect operation.Err/3Operating program blocked.Err/4Incorrect extract time programming.Err/5Error in dosings activation.Err/6Error in heating system activation.Err/7Error in rotation activation.Err/8Error in drain activation.Err/9Error in extract activation.Service modes (8)
- General Erase / Return to Basic Configuration["Access CONF 1 configuration step","Press the 0 key","Press ENTER/START key","Confirm by pressing…
- Inverter Configuration Verification (tESt)["Access CONF 1 configuration step","Close machine door","Access STAGE 9
- Inverter Parameters Loading (LOAd)["Access CONF 1 configuration step","Close machine door","Access STAGE 9
- Machine Configuration (CONF 1)["Ensure display shows idle state","Disconnect the External Automatic Switch","Remove top cover…
- Manual Mode["ON switch to I position","Programming selector to RUN position","Press MAN key","Wait for door…
- Model and EPROM Version Display["Ensure microprocessor is not in MANUAL MODE","Turn the key to Pro position","Press 0 key three…
- Operation Configuration (CONF 2)["Ensure display shows idle state","Insert the key inside the programming selector (fig
- Programming Mode (PROG)["Insert the key in the programming access selector","Turn to PROG position","Display will show…
Full entry steps, exit procedures, and test sequences are available in Max.
Related Cont Girbau washer models
75,000+ service documents · 20,000+ error codes · 100+ brands
Get Started$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax