Model reference

Frigidaire 4881

Range

13 documents18 error codes5 service modes

Available documentation

Tech Sheet

Service Data Sheet - Electric Oven with Modular Oven Controls2 pg
Covers this model
Cooktop Lockout Control Board / Electronic Oven Control Service Data Sheet4 pg
Covers this model

Service Manual

30" Single Electric Wall Oven - Service Manual11 pg
Covers this model
30" Wall Oven / Microwave Combo14 pg
Covers this model
30" Electric Wall Oven / Microwave Combo14 pg
Covers this model
30-INCH Slide-in Dual Fuel Range Service Data Sheet15 pg
Covers this model
30-INCH Slide-in Dual Fuel Range Service Documentation15 pg
Covers this model
30-INCH SLIDE-IN ELECTRIC RANGE Service Documentation13 pg
Covers this model
30" Double Electric Wall Oven EW30EW65GS815 pg
Covers this model
30-INCH Slide-in Gas Range15 pg
Covers this model

Installation Guide

ELECTRIC WALL OVEN INSTALLATION INSTRUCTIONS (27" and 30" Ovens with Optional Electric or Gas Cooktop Combination)16 pg
Covers this model
Installation Instructions - Freestanding Gas Range20 pg
Covers this model

Other

59955569736 pg
Covers this model

MyPros+ Max

Diagnose your Frigidaire 4881.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax

Error codes (18)

CodeMeaning

ASAmbient thermistor sensor located in the remote control has failed.CLClose and latch the door.ESEvaporator thermistor sensor has failed.F10Runaway temperature F11Shorted keypad or selector switch.F12EOC internal software error or failure.F13Door lock motor or latch circuit failure.F14Membrane switch tail missing or not connected.F20Communication failure between EOC and ESEC system.F30Open oven sensor probe circuit.F31Shorted oven sensor probe circuit.HdWater heating delay.HOWater heating delay.HSHeat thermistor sensor has failed (heat capable models only).LOLow liquid in the rinse aid dispenser.OPTION LED's FlashingAll option LEDs flashing indicates a power failure has occurred.PFA power failure has occurred.STATUS LED's FlashingThe STATUS LEDs that are lit when the door is opened will flash, indicating the…

Service modes (5)

Controls LockPress and hold the RINSE HOLD or NO HEAT DRY pad for 3 seconds.
Oven Temperature Calibration Adjustment["Set EOC to bake at 550°F.","Within 5 seconds of setting 550°F, press and hold the bake pad for…
Water/Service Test (from Idle Mode)While in Idle Mode, simultaneously press the HI-TEMP WASH and START/CANCEL pads for 6 seconds
Water/Service Test (from Power Failure Mode)While in Power Failure Mode, simultaneously press the AIR DRY and START/CANCEL pads for 1½ seconds
Water/Service Test (WST)["From idle mode

Full entry steps, exit procedures, and test sequences are available in Max.

Related Frigidaire range models

75,000+ service documents · 20,000+ error codes · 100+ brands

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax