Model reference

GE GDF510PGM4WW

Dishwasher

3 documents47 error codes5 service modes

Available documentation

Service Manual

2012 Plastic Tub Dishwasher - Hybrid SS Inner Door or Plastic Inner Door119 pg
Covers this model
Technical Service Guide79 pg
Covers this model

Training

InfiniClean Dishwasher Training Presentation110 pg
Covers this model

MyPros+ Max

Diagnose your GE GDF510PGM4WW.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·GE Dishwasher

AcF on my GE GDF510PGM4WW

M+

High supply voltage - supply voltage is

From Service Manual 101281, p.13:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure control board supply voltage at test points. Expected: 12 VDC and 5 VDC.

3.Inspect all connectors on the main control for corrosion or backed-out pins.

Part WR55X10942

Main control board

Error codes (47)

CodeMeaning

AcFHigh supply voltage AdcInternal board failure (critical fault).CFEContinuous fill error (critical fault).Clean LEDTurbidity Sensor Error dLFDoor latch failure (critical fault).F1Communication error with User Interface (UI) board.F112Key stuck.F128Low rinse aid detected.F153Door latch failure.F155Key stuck.F16High water temperature.F32Water level sensor invalid.F33Low pressure sensor reading.F34Leak detected.F36CSM tripped (CSM lock out).F37Diverter feedback error.F48Turbidity sensor high.F49Turbidity sensor low.F50Temperature sensor high.F51Temperature sensor low.F52Turbidity sensor calibration fail.F53Circulating pump failure.F54Drain pump failure.F55Blown pump fuse on main control board.F56Failure to drain.F58Dry heater thermistor error F59Dry heater thermistor error F60Heater relay stuck on fault.F61CSM check failed.F62Dry heater fan error.

View all 47 error codes

F63Flood condition fault F64Ignore fault.F66Dry heater fault.F86No fill failure.F87Dry heater diagnostic fault.F96Ignore fault.F97Absent heat source.F98Non-draining sump (turbidity based).F99Minimum wash temperature not met.FtdFailure to drain (critical fault).FuSBoard circulation pump fuse failure (critical fault).H20Water supply failure (critical fault).Heated Dry LEDWash Temperature Error HrfInternal board failure (critical fault).PrSPressure sensor failure (critical fault).Start LEDCommunications Failure Wash Boost LEDThermistor Error

Service modes (5)

Demo Mode["Press and hold Heated Dry and Start simultaneously for 5 seconds."]
Demo Mode ExitTo exit Demo Mode, hold SELECT CYCLE and HEATED DRY at the same time for 5-seconds.
Error Code Mode["Press Select Cycle.","Press and hold Start for 5 seconds."]
Error ModeWith the dishwasher in Standby Mode (not running a cycle), press and hold the furthest most pad on…
Service Mode["First enter Error Code Mode (Press Select Cycle, then press and hold Start for 5…

Full entry steps, exit procedures, and test sequences are available in Max.

Related GE dishwasher models

78,000+ service manuals · 160,000+ error codes · 55+ brands

$29/month · Cancel anytime · Or $9.95 3-day pass