Model reference
GE GDT530PSD2SS
Dishwasher
3 documents47 error codes5 service modes
Available documentation
Service Manual
- 2012 Plastic Tub Dishwasher - Hybrid SS Inner Door or Plastic Inner Door119 pg
- Technical Service Guide79 pg
Training
- TB07-15 GE Dishwasher Training Bulletin Current Sense Module5 pg
MyPros+ Max
Diagnose your GE GDT530PSD2SS.
- Step-by-step diagnostics from the service manual
- Test values, resistance specs, and wiring references
- Verified part numbers when replacement is needed
Start diagnosing
$29/month · Cancel anytime · Or $9.95 3-day pass
Error codes (47)
CodeMeaning
AcFHigh supply voltageAdcInternal board failure (critical fault).CFEContinuous fill error (critical fault).Clean LEDTurbidity Sensor ErrordLFDoor latch failure (critical fault).F1Communication error with User Interface (UI) board.F112Key stuck.F128Low rinse aid detected.F153Door latch failure.F155Key stuck.F16High water temperature.F32Water level sensor invalid.F33Low pressure sensor reading.F34Leak detected.F36CSM tripped (CSM lock out).F37Diverter feedback error.F48Turbidity sensor high.F49Turbidity sensor low.F50Temperature sensor high.F51Temperature sensor low.F52Turbidity sensor calibration fail.F53Circulating pump failure.F54Drain pump failure.F55Blown pump fuse on main control board.F56Failure to drain.F58Dry heater thermistor errorF59Dry heater thermistor errorF60Heater relay stuck on fault.F61CSM check failed.F62Dry heater fan error.View all 47 error codes
F63Flood condition faultF64Ignore fault.F66Dry heater fault.F86No fill failure.F87Dry heater diagnostic fault.F96Ignore fault.F97Absent heat source.F98Non-draining sump (turbidity based).F99Minimum wash temperature not met.FtdFailure to drain (critical fault).FuSBoard circulation pump fuse failure (critical fault).H20Water supply failure (critical fault).Heated Dry LEDWash Temperature ErrorHrfInternal board failure (critical fault).PrSPressure sensor failure (critical fault).Start LEDCommunications FailureWash Boost LEDThermistor Error
Service modes (5)
- Demo Mode["Press and hold Heated Dry and Start simultaneously for 5 seconds."]
- Demo Mode ExitTo exit Demo Mode, hold SELECT CYCLE and HEATED DRY at the same time for 5-seconds.
- Error Code Mode["Press Select Cycle.","Press and hold Start for 5 seconds."]
- Error ModeWith the dishwasher in Standby Mode (not running a cycle), press and hold the furthest most pad on…
- Service Mode["First enter Error Code Mode (Press Select Cycle, then press and hold Start for 5…
Full entry steps, exit procedures, and test sequences are available in Max.
Related GE dishwasher models
78,000+ service manuals · 160,000+ error codes · 55+ brands
Get Started$29/month · Cancel anytime · Or $9.95 3-day pass