mypros+
Model reference

GE GDT535PXM4XX

Dishwasher

5 documents48 error codes6 service modes

Available documentation

Service Manual

  • Technical Service Guide79 pg
    Covers this model
  • Technical Service Guide - 2015 Plastic Tub Dishwasher73 pg
    Covers this model
  • 2012 Plastic Tub Dishwasher - Hybrid SS Inner Door or Plastic Inner Door119 pg
    Covers this model

Training

  • TB07-15 GE Dishwasher Training Bulletin Current Sense Module5 pg
    Covers this model

Other

  • TB12 183 pg
    Covers this model
MyPros+ Max

Diagnose your GE GDT535PXM4XX.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (48)

CodeMeaning
AcFHigh supply voltageAdcInternal board failure (critical fault).CFEContinuous Fill ErrorClean LEDTurbidity sensor errordLFDoor latch failure (critical fault).F1Communication error with User Interface (UI) board.F112Key stuck.F128Low rinse aid detected.F153Door latch failure.F155Key stuck.F16High water temperature.F32Water level sensor invalid.F33Low pressure sensor reading.F34Leak detected.F36CSM tripped (CSM lock out).F37Diverter feedback error.F48Turbidity sensor high.F49Turbidity sensor low.F50Temperature sensor high.F51Temperature sensor low.F52Turbidity sensor calibration fail.F53Circulating pump failure.F54Drain pump failure.F55Blown pump fuse on main control board.F56Failure to drain fault code.F58Dry heater thermistor errorF59Dry heater thermistor errorF60Heater relay stuck on fault.F61CSM check failed.F62Dry heater fan error.
View all 48 error codes
F63Flood condition faultF64Ignore fault.F66Dry heater fault.F86No fill failure.F87Dry heater diagnostic fault.F96Ignore fault.F97Absent heat source.F98Non-draining sump (turbidity based).F99Minimum wash temperature not met.FtdFailure to drain (critical fault).FuSBoard circulation pump fuse failure (critical fault).H20No water detectedHeated Dry LEDMinimum wash temperature of 120°F was not reached in 3 of the past 5 wash…HrfInternal board failure (critical fault).PrFPressure sensor failurePrSPressure sensor signal is undetectable or out of range, causing the cycle to be…Start LEDCommunications failureWash Boost LEDWash thermistor error

Service modes (6)

  • Consumer Error ModeWith the dishwasher in Standby Mode (not running a cycle), press and hold the Cycle Select and…
  • Demo ModeNot specified in document (mode is detected via Service LED showing 6 blinks per 3 seconds).
  • Demo Mode ExitHold SELECT CYCLE and HEATED DRY at the same time for 5 seconds to exit Demo Mode.
  • Error Code Mode["Press Select Cycle.","Press and hold Start for 5 seconds."]
  • Error ModeWith the dishwasher in Standby Mode (not running a cycle), press and hold the furthest most pad on…
  • Service Mode1

Full entry steps, exit procedures, and test sequences are available in Max.

Related GE dishwasher models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass