Model reference

GE GDT635HXM0XX

Dishwasher

3 documents48 error codes5 service modes

Available documentation

Service Manual

Technical Service Guide79 pg
Covers this model
Technical Service Guide - 2015 Plastic Tub Dishwasher73 pg
Covers this model

Other

TB12 183 pg
Covers this model

MyPros+ Max

Diagnose your GE GDT635HXM0XX.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·GE Dishwasher

AcF on my GE GDT635HXM0XX

M+

High supply voltage - supply voltage is

From Service Manual 907636, p.48:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure control board supply voltage at test points. Expected: 12 VDC and 5 VDC.

3.Inspect all connectors on the main control for corrosion or backed-out pins.

Part WR55X10942

Main control board

Error codes (48)

CodeMeaning

AcFHigh supply voltage AdcInternal board failure (critical fault).CFEContinuous Fill Error Clean LEDTurbidity sensor error dLFDoor latch failure (critical fault).F1Communication error with User Interface (UI) board.F112Key stuck.F128Low rinse aid detected.F153Door latch failure.F155Key stuck.F16High water temperature.F32Water level sensor invalid.F33Low pressure sensor reading.F34Leak detected.F36CSM tripped (CSM lock out).F37Diverter feedback error.F48Turbidity sensor high.F49Turbidity sensor low.F50Temperature sensor high.F51Temperature sensor low.F52Turbidity sensor calibration fail.F53Circulating pump failure.F54Drain pump failure.F55Blown pump fuse on main control board.F56Failure to drain fault code.F58Dry heater thermistor error F59Dry heater thermistor error F60Heater relay stuck on fault.F61CSM check failed.F62Dry heater fan error.

View all 48 error codes

F63Flood condition fault F64Ignore fault.F66Dry heater fault.F86No fill failure.F87Dry heater diagnostic fault.F96Ignore fault.F97Absent heat source.F98Non-draining sump (turbidity based).F99Minimum wash temperature not met.FtdFailure to drain (critical fault).FuSBoard circulation pump fuse failure (critical fault).H20No water detected Heated Dry LEDMinimum wash temperature of 120°F was not reached in 3 of the past 5 wash…HrfInternal board failure (critical fault).PrFPressure sensor failure PrSPressure sensor signal is undetectable or out of range, causing the cycle to be…Start LEDCommunications failure Wash Boost LEDWash thermistor error

Service modes (5)

Consumer Error ModeWith the dishwasher in Standby Mode (not running a cycle), press and hold the Cycle Select and…
Demo ModeNot specified in document (mode is detected via Service LED showing 6 blinks per 3 seconds).
Demo Mode ExitHold SELECT CYCLE and HEATED DRY at the same time for 5 seconds to exit Demo Mode.
Error ModeWith the dishwasher in Standby Mode (not running a cycle), press and hold the furthest most pad on…
Service Mode1

Full entry steps, exit procedures, and test sequences are available in Max.

Related GE dishwasher models

78,000+ service manuals · 160,000+ error codes · 55+ brands

$29/month · Cancel anytime · Or $9.95 3-day pass