Model reference
GE JGB918
Range
3 documents13 error codes2 service modes
Available documentation
Service Manual
- Safety Instructions and Operating Instructions64 pg
- TECHNICAL SERVICE GUIDE XL44TM Self-Cleaning Gas Convection Ranges30 pg
Training
- GE Profile 30" Self-Clean Gas Ranges with Convection Oven4 pg
MyPros+ Max
Diagnose your GE JGB918.
- Step-by-step diagnostics from the service manual
- Test values, resistance specs, and wiring references
- Verified part numbers when replacement is needed
Start diagnosing
$29/month · Cancel anytime · Or $9.95 3-day pass
Error codes (13)
CodeMeaning
ErrDisplayed when a time or temperature outside of the control's limits has been…FFunction error code indicated by 'F- and a number or letter' flashing in the…F0Stuck key pad or transistor failure; may mean relay is turned on.F1Stuck key pad or transistor failure; may mean relay is turned on.F2Oven over-temperature conditionF3Open oven sensor circuit (over 2700 ohms) or shorted sensor circuit (under 950…F4Open oven sensor circuit (over 2700 ohms) or shorted sensor circuit (under 950…F5Loss of relay drive circuit.F7Stuck key pad or transistor failure; may mean relay is turned on.FCProblem with door lock circuit such as pinched wires between control and door…FFDoor motor safety switch transistor failure.LOCControl lockout is active; touch pads are locked and cannot be activated.LOCK DOORSelf-clean cycle has been selected but the door is not closed or the latch was…Service modes (2)
- Fault Code Memory DisplayRefer to page 14 of the service guide for the fault code memory display procedure (specific button…
- On-Board Diagnostic TestsRefer to page 16 of the service guide for on-board diagnostic test entry procedures (specific…
Full entry steps, exit procedures, and test sequences are available in Max.
Related GE range models
78,000+ service manuals · 160,000+ error codes · 55+ brands
Get Started$29/month · Cancel anytime · Or $9.95 3-day pass