Model reference
GE JGB920SEC4SS
Range
3 documents9 error codes2 service modes
Available documentation
Service Manual
- XL44TM Self-Cleaning Gas Convection Ranges Technical Service Guide30 pg
- TECHNICAL SERVICE GUIDE XL44TM Self-Cleaning Gas Convection Ranges30 pg
Training
- GE Profile 30" Self-Clean Gas Ranges with Convection Oven4 pg
MyPros+ Max
Diagnose your GE JGB920SEC4SS.
- Step-by-step diagnostics from the service manual
- Test values, resistance specs, and wiring references
- Verified part numbers when replacement is needed
Start diagnosing
$29/month · Cancel anytime · Or $9.95 3-day pass
Error codes (9)
CodeMeaning
F0Stuck key pad or transistor failure; may mean relay is turned on.F1Stuck key pad or transistor failure; may mean relay is turned on.F2Oven over-temperature conditionF3Open oven temperature sensor circuit (over 2700 ohms) or shorted sensor circuit…F4Open oven temperature sensor circuit (over 2700 ohms) or shorted sensor circuit…F5Loss of relay drive circuit.F7Stuck key pad or transistor failure; may mean relay is turned on.FCProblem with door lock circuit such as pinched wires between control and door…FFDoor motor safety switch transistor failure.Service modes (2)
- Fault Code Memory DisplayRefer to page 14 of the service guide for fault code memory display procedure.
- On-Board Diagnostic TestsRefer to page 16 of the service guide for on-board diagnostic test procedures.
Full entry steps, exit procedures, and test sequences are available in Max.
Related GE range models
78,000+ service manuals · 160,000+ error codes · 55+ brands
Get Started$29/month · Cancel anytime · Or $9.95 3-day pass