Model reference
GE RS744GN
Range
1 document10 error codes4 service modes
Available documentation
Service Manual
- GE 30 Inch Slide In Electric Range RS734GN Basic Operating and erc troubleshooting30 pg
MyPros+ Max
Diagnose your GE RS744GN.
- Step-by-step diagnostics from the service manual
- Test values, resistance specs, and wiring references
- Verified part numbers when replacement is needed
Start diagnosing
$29/month · Cancel anytime · Or $9.95 3-day pass
Error codes (10)
CodeMeaning
F0Failed transistor in the Electronic Range Control (ERC).F1Failed transistor in the Electronic Range Control (ERC).F2Oven exceeded 590°F with door in unlocked position or exceeded 990°F with door…F3Open sensor circuit or sensor, sensor lead shorted to ground, or intermittent…F4Shorted sensor or short in sensor harnessF5Failed transistor in the Electronic Range Control (ERC).F6Problem within timekeeping circuits due to fluctuation of the 60 Hz power…F7Stuck function switch or button (BAKE, BROIL, CLEAN, etc.) on ERC.F8Component failure detected within ERC affecting temperature processing circuits.F9Problem with door lock circuit such as a pinched wire between ERC and door lock…Service modes (4)
- End-of-Cycle Tone Toggle (ERC-II)Press and hold the CLEAR/OFF pad for 12 seconds to change the End-of-Cycle tone from repeating 3…
- Key Tone Disable/Enable (ERC-I)Push and hold the oven CANCEL button until you hear a short beep (approximately two seconds) to…
- Oven Temperature Calibration (ERC-I)1. Push the BAKE button. 2. Select a temperature between 500°F and 550°F with the SET knob. 3…
- Oven Temperature Calibration (ERC-II)1
Full entry steps, exit procedures, and test sequences are available in Max.
Related GE range models
78,000+ service manuals · 160,000+ error codes · 55+ brands
Get Started$29/month · Cancel anytime · Or $9.95 3-day pass