mypros+
Model reference

Haier HWF5300AW

Washer

3 documents20 error codes6 service modes

Available documentation

Service Manual

  • Haier Front Load Washer HWF5300AW Series Service Manual39 pg
    Covers this model
  • SERVICE MANUAL HWF5300AW series1 pg
    Covers this model
  • User Manual30 pg
    Covers this model
MyPros+ Max

Diagnose your Haier HWF5300AW.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (20)

CodeMeaning
ErLCThe door cannot be locked.Err10Lost communication between the power board and the display board.Err11Heating resistor relay may be broken.Err12Lost communication between the power board and the user interface.Err13EEPROM corrupted.Err2Drainage errorErr3Temperature sensor is not properly connected or damaged.Err4The heater may be broken.Err5The required water level is not reached within 8 minutes.Err6Motor speed errorErr7Motor speed errorErr8Water level exceeds protection value.Err9Lost communication between the Display board and Touch board.Error 1Door is not properly shut; the door lock light does not illuminate.Error 2Drainage error; water not emptied within 4 minutesError 3Water level not met in 8 minutesError 4Timing control damageError 5Motor overheat protection or damageError 6Water exceeds protective levelErULThe door lock cannot be opened (unlocked).

Service modes (6)

  • Full Self-Check (Indicator lights, Door lock, Water inlet valve test)["Enter Self Test mode (display shows tESt).","Press START/PAUSE to start self-checking.","All…
  • Motor Test (within Self Test)["Enter Self Test mode (display shows tESt).","Press SPIN SPEED to start motor test
  • Self Test / Diagnostic Mode["Press POWER to power on the machine.","Select ACTIVE WEAR cycle for PROGRAM cycle.","SPIN SPEED…
  • Temperature Sensor Test (within Self Test)["Enter Self Test mode (display shows tESt).","Press and hold WATER TEMP button.","LED display will…
  • Water Level Sensor Test (within Self Test)["Enter Self Test mode (display shows tESt).","Press and hold SOIL LEVEL or RINSE LEVEL…
  • Water Pump and Motor Spin Test (within Self Test)["Complete the full self-check test first.","Press POWER to turn off, wait 5 seconds, press POWER…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Haier washer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass