mypros+
Model reference

Hardwick D-950

Range

2 documents33 error codes2 service modes

Available documentation

Tech Sheet

  • Tech Sheet - 976106312 pg
    Covers this model

Tech Tip

  • Instruction Sheet - 975766112 pg
    Covers this model
MyPros+ Max

Diagnose your Hardwick D-950.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax

Error codes (33)

CodeMeaning
F0 E0No failure (default state).F1 E0Internal error on the display board.F1 E1Internal error on the display board.F1 E2Internal error on the display board.F1 E3Internal error on the display board.F1 E4Internal error on the display board.F1 E5Internal error on the power board.F1 E6Internal error on the power board.F1 E7Internal error on the power board.F1 E8Internal error on the power board.F1 E9Internal error on the display board.F2Touch panel failure.F2 E0Stuck key (shorted key) on keypad.F2 E1Keypad disconnected.F3 E0Main oven sensor open (top oven sensor opened).F3 E1Main oven sensor shorted (top oven sensor shorted).F3 E2Meat probe shorted.F3 E4Bottom oven sensor open (bottom/lower oven sensor open).F3 E5Lower/bottom oven sensor shorted.F3 E6Warming drawer sensor open.F3 E7Warming drawer sensor shorted.F3HHumidity sensor failure.F4 E2Over temperature during cook mode (temperature runaway).F4 E3Over temperature during clean mode (temperature runaway).F4 E7Over temperature cavity 2 (temperature runaway error).F5 E0Door latch mismatchF5 E1Latch not operating (no operating latch).F5 E2Door switch fault.F5 E4Latch switch fault.F5 E7Unlock door error
View all 33 error codes
F6Microwave relay failure.F6 E4Lost communication between power board and display board.F6 E5Cancel key error.

Service modes (2)

  • Diagnostics mode["Press the Cancel key to place the range in an idle state.","Press the Cancel and Start keys in…
  • Touch Panel and Electronic Control Self-Diagnostic Test Mode["Press and hold the OFF/CANCEL button while opening the door.","While still holding the OFF/CANCEL…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Hardwick range models

75,000+ service documents · 20,000+ error codes · 100+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax