Model reference

Jenn-Air JDB9200CWX4

Name: Jenn-Air JDB9200CWX4
Brand: Jenn-Air

Dishwasher

1 document28 error codes2 service modes

Available documentation

Tech Sheet

Tech Sheet12 pg
Covers this model

MyPros+ Max

Diagnose your Jenn-Air JDB9200CWX4.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Jenn-Air Dishwasher

F10E1 on my Jenn-Air JDB9200CWX4

M+

Dispenser electrical problem; loose

From Tech Sheet W18053985, p.37:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure control board supply voltage at test points. Expected: 12 VDC and 5 VDC.

3.Inspect all connectors on the main control for corrosion or backed-out pins.

Part WPW10804018

Electronic control board

Error codes (28)

CodeMeaning

F10E1Dispenser electrical problem; loose connection in Dispenser Circuit and/or open…F10E2Vent wax motor electrical problem; loose connection in vent circuit and/or open…F10E3Drying fan error; loose connection in fan circuit and/or open fan motor (on…F1E1Control detected K400 pilot relay stuck closed.F1E2Damaged or corrupted memory on control board (control software issue).F2E1Control detected stuck key(s) in keypad or keypad connection.F2E2User Interface cannot communicate with main control; loose User Interface…F3E1Open connector or component in Temperature Sensing Circuit (open or faulty…F3E2Incoming water temperature above 167°F (75°C) or shorted connection/component…F3E3OWI sensor failed calibration.F4E4Loose connection in Wash Motor Circuit and/or open wash motor; motor fuse open…F5E1Door was not latched within 3 seconds of pressing Start/Resume, or loose…F5E2Control programmed to not start if it suspects the door switch is stuck closed…F6E1No water to dishwasher (low/no water mechanical problem).F6E2Fill valve electrical problem; loose connection in Fill Valve Circuit and/or…F6E3Suds or air detected in pump.F6E4Float switch stuck in overfill (open) position and/or dishwasher not level.F6E7Disconnected or damaged flowmeter.F6E8Loose connection in Regen valve circuit, and/or open Regen valve solenoid…F7E1No heat; control disabled heater due to detected water heating problem, or open…F7E2Heater stuck on; heater drive circuit on the control failed.F8E1Slow drain; obstructed drain hose or path.F8E3Drain pump impeller fractured or damaged.F8E4Drain motor electrical problem; loose connection in Drain Motor Circuit and/or…F9E1Diverter can't find position; corroded or loose connection in diverter…F9E2Diverter stuck on; diverter drive circuit on the control failed.F9E3Control detected diverter disk in sump is missing.F9E4Lower spray arm error; mechanical binding/blocking or corroded/loose connection…

Service modes (2)

Rapid Advance (Customer Cycle)["Start a customer cycle.","Press HIGH TEMP
Service Diagnostics Cycle["Press START/RESUME to wake up control panel.","Press any 3 keys in the sequence 1-2-3-1-2-3-1-2-3…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Jenn-Air dishwasher models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass