mypros+
Model reference

Jenn-Air JMW2427DS01

Oven

5 documents28 error codes9 service modes

Available documentation

Tech Sheet

  • Tech Sheet - W10794417 - Rev B (FR)24 pg
    Covers this model

Service Manual

  • 27 & 30 Inch Microwave Combination Wall Ovens Job Aid60 pg
    Covers this model

Service Flash

  • Technical Service Pointer - W11803872 Rev B - Built In Oven Loose UI Board11 pg
    Covers this model

Installation Guide

  • Installation Instructions16 pg
    Covers this model
  • Installation Instructions2 pg
    Covers this model
MyPros+ Max

Diagnose your Jenn-Air JMW2427DS01.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (28)

CodeMeaning
F1-E0Oven User Interface (UI) Failure.F1-E1Internal Oven ACU (Appliance Control Unit) Error.F1-E4Microwave Oven Relay 4903 Error.F1-E5Microwave Oven Inverter Error.F1-E6Microwave Generation Error.F1E5Microwave inverter board communication or generation error.F1E6Microwave generation error related to door switches, MW Relay 4903, inverter…F2-E0Stuck/shorted key or keypad disconnected on the control panel.F2E0Keypad disconnected.F2E1Stuck or shorted key on keypad.F3-E0Main oven temperature sensor open or shorted.F3-E3Meat Probe Connector Jack or Meat Probe Shorted.F3E0Main oven temperature sensor open or shorted.F3E3Meat probe connector shorted.F4-E1Microwave Cavity Temperature Sensor Error.F4-E2Magnetron Temperature Sensor Error.F4-E4Microwave Oven Humidity Sensor Error.F4-E8Inverter Over Temperature.F4-E9Inverter and Magnetron Over Temperature.F4E1Microwave cavity temperature sensor error.F5-E0Door and latch switch do not agree.F5-E1Latch not operating.F6-E0Oven user interface lost communication with appliance manager.F6-E1Over temperature condition in the oven.F6-E4User Interface/Appliance Manager state status mismatch.F6-E6Oven appliance manager lost communication.F6-E8Lost communications with Microwave Oven Appliance Manager.F9-E0Product not wired correctly (neutral connection switched with L1 or L2).

Service modes (9)

  • component_activation["Enter diagnostic mode.","Scroll to 'Component Activation' in the diagnostic menu and press…
  • diagnostic["Press LOWER OVEN > LOWER LIGHT > OVEN CANCEL in sequence.","Repeat the above sequence two more…
  • Diagnostic Mode["Press LOWER OVEN, then LOWER LIGHT, then LOWER CANCEL.","Repeat the above sequence two more times…
  • Diagnostics ModePress LOWER OVEN > LOWER LIGHT > OVEN CANCEL, and repeat this sequence two more times (3 times…
  • error_diagnostics["Enter diagnostic mode.","Scroll to 'Error Diagnostics' in the diagnostic menu and press…
  • Model Selection (within Diagnostic Mode)["Plug in oven or connect power.","Enter Diagnostics Mode.","Touch or scroll to 'System…
  • model_selection["Enter diagnostic mode.","Scroll to 'System Information' and press 'OK'.","Scroll to 'Model…
  • sensors_and_switches["Enter diagnostic mode.","Scroll to 'Sensors & Switches' in the diagnostic menu and press…
  • system_information["Enter diagnostic mode.","Scroll to 'System Information' in the diagnostic menu and press…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Jenn-Air oven models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass