Model reference
Jenn-Air JMW3430HS00
Oven
5 documents22 error codes7 service modes
Available documentation
Tech Sheet
- Tech Sheet - W10767738 - Rev B24 pg
Tech Tip
- Instruction Sheet4 pg
Installation Guide
- Installation Instructions16 pg
- Instruction Sheet8 pg
- Installation Instructions2 pg
MyPros+ Max
Diagnose your Jenn-Air JMW3430HS00.
- Step-by-step diagnostics from the service manual
- Test values, resistance specs, and wiring references
- Verified part numbers when replacement is needed
Start diagnosing
$29/month · Cancel anytime · Or $9.95 3-day pass
Error codes (22)
CodeMeaning
F1-E0Oven User Interface (UI) FailureF1-E1Internal Oven ACU (Appliance Control Unit) ErrorF1-E4Microwave Oven Relay 4903 ErrorF1-E5Microwave Oven Inverter ErrorF1-E6Microwave Generation ErrorF2-E0Keypad disconnectedF2-E1Stuck/shorted keyF3-E0Main oven sensor open or shortedF3-E3Meat Probe Connector Jack or Meat Probe ShortedF4-E1Microwave Cavity Temperature Sensor ErrorF4-E2Magnetron Temperature Sensor ErrorF4-E4Microwave Oven Humidity Sensor ErrorF4-E8Inverter Over TemperatureF4-E9Inverter and Magnetron Over TemperatureF5-E0Door and latch switch do not agreeF5-E1Latch not operatingF6-E0Oven user interface lost communicationF6-E1Over temperatureF6-E4User Interface/Appliance Manager state status mismatchF6-E6Oven appliance manager lost communicationF6-E8Lost communications with Microwave Oven Appliance ManagerF9-E0Product not wired correctlyService modes (7)
- Component ActivationEnter Diagnostics Mode, then touch or scroll to 'Component Activation' and touch 'OK'
- Diagnostics ModePress LOWER OVEN > LOWER LIGHT > OVEN CANCEL, then repeat the same sequence two more times (total…
- Error DiagnosticsEnter Diagnostics Mode, then touch or scroll to 'Error Diagnostics' and touch 'OK'.
- Model SelectionEnter Diagnostics Mode, touch or scroll to 'System Information' and touch 'OK', then touch or…
- Sensors & SwitchesEnter Diagnostics Mode, then touch or scroll to 'Sensors & Switches' and touch 'OK'
- System InformationEnter Diagnostics Mode, then touch or scroll to 'System Information' and touch 'OK'
- Touch Calibration ResetEnter Diagnostic Menu, then touch POWER. To reset Touch Calibration
Full entry steps, exit procedures, and test sequences are available in Max.
Related Jenn-Air oven models
78,000+ service manuals · 160,000+ error codes · 55+ brands
Get Started$29/month · Cancel anytime · Or $9.95 3-day pass