mypros+
Model reference

Jenn-Air S100

Range

2 documents16 error codes4 service modes

Available documentation

Service Manual

  • Service Manual 16000416164 pg
    Covers this model
  • Electric Range Service Manual100 pg
    Covers this model
MyPros+ Max

Diagnose your Jenn-Air S100.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (16)

CodeMeaning
6ETemperature control error7ETemperature control error8EMalfunction in motor relay circuit.9EMalfunction in dryer door circuit.F1Element relay circuitF2Excessive cavity temperatureF3Oven temperature sensorF4Oven temperature sensorF5Shorted temperature probe, jack or harness.F6Main control board shorted (only time of day and minute timer will work).F7Clean/lock switch assembly shorted or open, or lock motor still runs.F8Door lock motor inoperative or open wiring to motor.IEWasher is in pause due to malfunction of the lid lock or the lid is not…LWasher is in pause due to the lid being open and unlocked.PWasher is in pause mode due to pressing Pause/Resume pad.UWasher is in pause due to an unbalance condition.

Service modes (4)

  • 38207 Circuit Board Diagnostic Test["Disconnect dryer power cord.","Remove lower access panel.","Disconnect 9 and 11 pin edgeboard…
  • Fast TestOn power up of the control, press and hold the COOK TIME key for at least 100 ms
  • Self-Diagnostic Test (Built-in)["Press the washer OFF pad.","Press the dryer OFF pad.","Press and hold the dryer Signal ON/OFF…
  • Thermostat Calibration (Electronic Models)1

Full entry steps, exit procedures, and test sequences are available in Max.

Related Jenn-Air range models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass