mypros+
Model reference

Kenmore 11068082700

Dryer

2 documents21 error codes3 service modes

Available documentation

Tech Sheet

  • Kenmore Dryer Technical Service Sheet16 pg
    Covers this model

Quick Reference

  • Quick Start Dryer Guide4 pg
    Covers this model
MyPros+ Max

Diagnose your Kenmore 11068082700.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax

Error codes (21)

CodeMeaning
AFRestricted air flow condition exists.F-01Primary control failure.F-02Stuck button or user interface mismatch (only appears in diagnostic test mode).F-22Exhaust thermistor is open.F-23Exhaust thermistor has shorted.F-24Inlet thermistor is open (only appears in diagnostic test mode).F-25Inlet thermistor is shorted (only appears in diagnostic test mode).F-26Motor drive system failure.F-28Moisture sensor strip is open (only appears in diagnostic test mode).F-29Moisture sensor strip has shorted (only appears in diagnostic test mode).F-30Restricted air flow condition (only appears in diagnostic test mode).F-40Communication between the machine control and motor control is lost.F-41Blower motor failure.F-42Motor control detects voltage less than 90 VAC (undervoltage failure).F-43Motor control detects a low voltage condition (undervoltage warning); dryer…F-44Motor control electronics failure.F-45Motor control electronics speed sensor failure.F-46Motor control detects an over-current or over-torque condition.F-50No voltage detected at the water valve relay (only appears in diagnostic test…L2Low or no line voltage detected (less than 50V) at installation.PFPower failure occurred while the dryer was running.

Service modes (3)

  • customer_focused_drying_mode_adjustment["Press and hold the Dryness Level button for 5 seconds.","Dryer will beep and display CF for one…
  • diagnostic["Ensure dryer is in standby mode (plugged in with all indicators off, or with only the Clothes Dry…
  • manual_load_test["Ensure dryer is in standby mode (plugged in with all indicators off, or with only the Clothes Dry…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Kenmore dryer models

75,000+ service documents · 20,000+ error codes · 100+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax