Model reference
Kenmore 79551072011
Refrigerator
3 documents11 error codes9 service modes
Available documentation
Service Manual
- SXS Freezer Refrigerator Refrigerator Service Manual135 pg
- SXS Freezer Refrigerator Refrigerator Service Manual134 pg
- SXS Freezer Refrigerator Service Manual134 pg
MyPros+ Max
Diagnose your Kenmore 79551072011.
- Step-by-step diagnostics from the service manual
- Test values, resistance specs, and wiring references
- Verified part numbers when replacement is needed
Start diagnosing
$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax
Error codes (11)
CodeMeaning
COCommunication errorEr CFCooling BLDC fan motor defective, fan blade obstructed, or short/open wire of…Er COCommunication errorEr dHDefective defrost heaterEr dSDefrost sensor short or open circuit detected.Er FFFreezer BLDC fan motor defective, fan blade obstructed, or short/open wire of…Er FSFreezer sensor short or open circuit detected.Er ISIcemaking sensor malfunctionEr r1Refrigerator sensor 1 (upper part in refrigerator compartment) short or open…Er r2Refrigerator sensor 2 (lower part in refrigerator compartment) short or open…Er rtAmbient (room temperature) sensor short or open circuit detected (secondary…Service modes (9)
- °C/°F TogglePress and hold the FREEZER TEMP and REFRIGERATOR TEMP keys at the same time for over 5 seconds.
- Demo Mode (OFF Mode / Demonstration Mode)Open the refrigerator door, then press and hold ULTRA ICE and REFRIGERATOR TEMP buttons…
- Display Check Mode (Error Code Check)Press ULTRA ICE and FREEZER TEMP buttons simultaneously for more than 5 seconds.
- Display Check Mode (LED Check Mode)Press ULTRA ICE and FREEZER TEMP buttons simultaneously for more than 5 seconds.
- Display OFF Mode (Standby Mode)Press FREEZER TEMP and ULTRA ICE buttons simultaneously; all LEDs turn ON, then after 5 seconds…
- Icemaker Test ModePress and hold the icemaker Fill Key (water amount selection button) for more than 3 seconds.
- Smart Diagnosis1) Open the R door
- Test Mode 1 (Freezing Force Mode)Press the TEST switch on the Main PCB once while in normal mode.
- Test Mode 2 (Compulsory Frost Removal Mode)From Test Mode 1, press the TEST switch on the Main PCB once more (second press).
Full entry steps, exit procedures, and test sequences are available in Max.
Related Kenmore refrigerator models
75,000+ service documents · 20,000+ error codes · 100+ brands
Get Started$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax