Model reference

KitchenAid KDTM384ESS

Dishwasher

1 document27 error codes2 service modes

Available documentation

Service Manual

2015 Microfiltration Dishwashers with Advanced ProDry™122 pg
Covers this model

MyPros+ Max

Diagnose your KitchenAid KDTM384ESS.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·KitchenAid Dishwasher

F10E1 on my KitchenAid KDTM384ESS

M+

Dispenser electrical problem - loose

From Tech Sheet W15486234, p.46:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure control board supply voltage at test points. Expected: 12 VDC and 5 VDC.

3.Inspect all connectors on the main control for corrosion or backed-out pins.

Part WPW10804018

Electronic control board

Error codes (27)

CodeMeaning

F10E1Dispenser electrical problem F10E3Drying fan error F1E1Control detected K2 pilot relay stuck closed.F1E2Damaged or corrupted memory on control board; incompatible software components…F2E1Control detected stuck key(s) in keypad or keypad connection.F3E1Open connection or component in temperature sensing circuit, open or faulty…F3E2Shorted connection or component in temperature sensing circuit, shorted or…F3E3OWI calibration failure.F4E1Loose connection in wash motor circuit and/or faulty wash motor.F4E3Control motor drive circuit or sense circuit failure.F5E1Door was not latched within 4 seconds of pressing Start/Resume, or loose…F5E2Control programmed to not start if it suspects the door switch is stuck closed…F6E1Low or no water to dishwasher (mechanical problem)F6E2Fill valve electrical problem F6E3Suds or air in pump F6E4Float switch stuck in overfill (open) position, dishwasher not level, drain…F6E7Disconnected or damaged flowmeter.F6E8Regeneration valve electrical problem F7E1No heat F7E2Heater stuck on F8E1Slow drain F8E2Drain motor electrical problem F8E3Drain stuck on F9E1Diverter can't find position F9E2Diverter stuck on F9E3Control detected diverter disk in sump is missing.F9E4Lower spray arm error

Service modes (2)

Rapid Advance Mode (Customer Cycles)After starting a customer cycle, press HIGH TEMP
Service Diagnostic CycleWith dishwasher in standby, press any 3 keys in the sequence 1-2-3-1-2-3-1-2-3 with no more than 1…

Full entry steps, exit procedures, and test sequences are available in Max.

Related KitchenAid dishwasher models

78,000+ service manuals · 160,000+ error codes · 55+ brands

$29/month · Cancel anytime · Or $9.95 3-day pass