Model reference

KitchenAid KEMS309BSS01

Microwave

6 documents25 error codes4 service modes

Available documentation

Tech Sheet

Tech Sheet - W10492441 - Rev A32 pg
Covers this model

Service Manual

Technical Education Job Aid 4317316 KAC-25 Built-in Microwave / Oven Combination92 pg
Covers this model
KitchenAid Built-In Microwave/Oven Combination92 pg
Covers this model

Tech Tip

installerlabel-w10643344-reva.pdf2 pg
Covers this model

Installation Guide

Installation Instructions16 pg
Covers this model

Other

W106894086 pg
Covers this model

MyPros+ Max

Diagnose your KitchenAid KEMS309BSS01.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·KitchenAid Microwave

E0 on my KitchenAid KEMS309BSS01

M+

Keypad not connected, or key held down

From Tech Sheet W15084950, p.42:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure control board supply voltage at test points. Expected: 12 VDC and 5 VDC.

3.Inspect all connectors on the main control for corrosion or backed-out pins.

Part WPW10804018

Electronic control board

Error codes (25)

CodeMeaning

E0Keypad not connected, or key held down too long, or key is shorted E1Temperature sensor opened (when displayed on upper/left side) or temperature…E1 E5Oven user interface failure.E3Keypad error F0Default F code F1Electronic control malfunction (when E code is not E3); or keypad not connected…F2Door latch error during Self-Clean F2 E0Keypad disconnected.F2 E1Stuck/shorted key on keypad.F3Temperature sensor opened (E0) or temperature sensor shorted (E1).F3 E0Oven sensor (humidity sensor 1600 or oven cavity sensor) open or shorted.F3 E4Microwave Oven Humidity Sensor Error.F3 EOOven sensor open or shorted (humidity sensor 1600).F4 E1Main oven sensor open or shorted.F4 E4Microwave Oven Cavity Temperature Sensor error (thermistor failure).F5Oven temperature too high F5 E0Door and latch switch do not agree.F5 E1Latch not operating.F5 EODoor and latch switch do not agree.F6 E0Oven user interface F6 E1Over temperature during operation/self-clean.F6 E5No cavity size command.F6 E6Oven appliance manager 1 (upper, single)F6 E8Lost communications with Microwave Oven Appliance Manager.Microwave Oven Inverter ErrorMicrowave oven inverter communication or operation error.

Service modes (4)

Diagnostics Mode 1Within 2 minutes of power up, press CANCEL > CANCEL > START
Diagnostics Mode 2After 2 minutes of power up, press CANCEL > CANCEL > START
Mode 1 - Full Diagnostic (within 2 minutes of power up)1. Power up the oven. 2. Within 2 minutes of power up, press CANCEL > CANCEL > START. 3. If control…
Mode 2 - Limited Diagnostic (after 2 minutes of power up)1

Full entry steps, exit procedures, and test sequences are available in Max.

Related KitchenAid microwave models

78,000+ service manuals · 160,000+ error codes · 55+ brands

$29/month · Cancel anytime · Or $9.95 3-day pass