mypros+
Model reference

KitchenAid KEBU107SSS03

Oven

7 documents22 error codes5 service modes

Available documentation

Tech Sheet

  • Tech Sheet - 8304549A12 pg
    Covers this model
  • Tech Sheet - 8304550A (FR)12 pg
    Covers this model

Service Flash

  • Technical Service Pointer #W10555846A - KitchenAid 27" and 30" Wall Ovens3 pg
    Covers this model
  • Service Pointer - W10555846 - Rev C (Inner Door Glass)3 pg
    Covers this model

Tech Tip

  • Instruction Sheet - W11808300 - Rev A - Filter Assembly vs Water Filter1 pg
    Covers this model

Installation Guide

  • Installation Instructions20 pg
    Covers this model

Quick Reference

  • Quick Reference Manual2 pg
    Covers this model
MyPros+ Max

Diagnose your KitchenAid KEBU107SSS03.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (22)

CodeMeaning
F0E0No fault (good condition)F1E0Check oven user interfaceF1E1Check oven appliance managerF2E0Keypad disconnected.F2E1Stuck or shorted key on keypad.F3E0Main oven sensor shorted or open circuit.F3E1Lower main oven sensor shorted or open circuit.F3E2Warming drawer sensor shortedF3E3Meat probe shorted.F5E0Door and latch switch do not agree (mismatch between door switch and latch…F5E1Door latch not operating.F6E0Lost communications between user interface and appliance manager.F6E1Cook oven over temperature.F6E2Clean oven over temperature.F6E3Mini oven/warm drawer over temperatureF6E4User interface / appliance manager mismatch.F6E5No cavity size commandF7E0Water is not high enough or water did not boil fast enough.F7E1Boiler over temperature.F7E2Boiler NTC out of range.F7E3Improper filter reset.F7E4Conductivity sensor not connected.

Service modes (5)

  • Diagnostic Menu - Extended Mode["Plug in oven or connect power","Enter Diagnostics (place control in application)","Connect…
  • Diagnostic Mode["Press OFF","Press OFF","Press START"]
  • Diagnostic Mode (Extended Mode)["Press OFF","Press OFF","Press START","Verify fault codes are displayed"]
  • Programming Mode (After User Interface Replacement)["Disconnect oven power","Replace user interface","Reassemble panels before powering on","Reconnect…
  • Relay Activation Test["Enter diagnostic mode (OFF, OFF, START)","Press RELAY ACTIVATION","Select relay (BAKE, INNER…

Full entry steps, exit procedures, and test sequences are available in Max.

Related KitchenAid oven models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass