Model reference
KitchenAid KEHU309SSS00
Oven
10 documents28 error codes6 service modes
Available documentation
Service Flash
- Service Pointer - 4317423 - Rev A - Meat Probe Error4 pg
- Service Pointer - Meat Probe Error Code2 pg
- Technical Service Pointer #W10555846A - KitchenAid 27" and 30" Wall Ovens3 pg
- Service Pointer - W10555846 - Rev C (Inner Door Glass)3 pg
- Service Pointer - W10540280 (Door Latch Assembly)4 pg
Tech Tip
- Instruction Sheet - W11808300 - Rev A - Filter Assembly vs Water Filter1 pg
Quick Reference
- Quick Reference Manual2 pg
Installation Guide
- Installation Instructions20 pg
- Instruction Sheet2 pg
Other
- Service Pointer - 8178797 - Rev A (Microwave End of Cycle Operation)3 pg
MyPros+ Max
Diagnose your KitchenAid KEHU309SSS00.
- Step-by-step diagnostics from the service manual
- Test values, resistance specs, and wiring references
- Verified part numbers when replacement is needed
Start diagnosing
$29/month · Cancel anytime · Or $9.95 3-day pass
Error codes (28)
CodeMeaning
F0E0No error detected (default state).F1E0Internal failureF1E1Internal failureF1E3Internal failureF1E4Internal failureF1E5Internal errorF2E0Keypad disconnected from the control.F2E1Stuck key or shorted key detected on keypad.F3E0Upper main oven sensor shorted or open.F3E1Lower oven sensor open or shorted.F3E2Warming drawer sensor shortedF3E3Meat probe sensor shorted.F4E1Microwave convection thermistor fault.F4E2Microwave internal temperature sensor fault.F4E4Microwave humidity sensor fault.F5E0Mismatch between door switches and latch switches.F5E1Door latch does not function.F6E0Loss of communication between user interface and appliance manager.F6E1Excessive oven temperature in Bake mode.F6E2Excessive oven temperature in Clean mode.F6E3Excessive temperature in warming drawer / mini oven.F6E4No cavity size command programmed.F6E5User interface / appliance manager mismatch.F7E0Insufficient water level, or excessive heating time to boil water (steam…F7E1Boiler over temperature condition.F7E2Boiler NTC temperature sensor out of range.F7E3Incorrect filter reset.F7E4Conductivity sensor not connected.Service modes (6)
- diagnosticPress OFF, OFF, START on the control panel.
- Diagnostics Menu - Extended Mode1. Enter Diagnostics Mode (OFF, OFF, START). 2. From the Diagnostics Main Menu, access sub-menus
- Diagnostics ModePress OFF, OFF, START.
- extended_diagnosticFrom the diagnostic main menu, navigate to the Extended Mode options (Relay Activation, Status…
- model_id_and_cavity_size_programmingAfter replacing user interface
- relay_activation_testFrom diagnostic mode, press RELAY ACTIVATION
Full entry steps, exit procedures, and test sequences are available in Max.
Related KitchenAid oven models
78,000+ service manuals · 160,000+ error codes · 55+ brands
Get Started$29/month · Cancel anytime · Or $9.95 3-day pass