mypros+
Model reference

KitchenAid KERH507YWH2

Range

12 documents57 error codes36 service modes

Available documentation

Tech Sheet

  • Tech Sheet - 9750877.pdf6 pg
    Covers this model
  • Kitchenaid Range KERI500YAL3 KERI500YAL4 Tech Sheet 97508776 pg
    Covers this model

Service Manual

  • Kitchenaid Electronic Range Controls "B" & D Line Wall Ovens Job Aid93 pg
    Covers this model
  • Whirlpool KAC 22 Failure Codes Wiring Diagrams for Freestanding Slide in Ranges and Built in Ovens34 pg
    Covers this model
  • kac-22-whrlpl34 pg
    Covers this model
  • kitchenaid-failure32 pg
    Covers this model
  • Job Aid - 4317266 (KAC-22)33 pg
    Covers this model
  • Electronic Oven Controls - Job Aid 431726633 pg
    Covers this model
  • KitchenAid Electronic Range Controls "B" & "D" Line Wall Ovens Job Aid93 pg
    Covers this model

Training

  • Failure Codes & Wiring Diagrams for KitchenAid Freestanding & Slide-In Ranges And Built-In Ovens32 pg
    Covers this model

Installation Guide

  • Installation Instructions5 pg
    Covers this model

Quick Reference

  • Quick Reference Manual2 pg
    Covers this model
MyPros+ Max

Diagnose your KitchenAid KERH507YWH2.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (57)

CodeMeaning
F1Control out of calibration.F1 E0EEPROM read fault (silent fault, not displayed).F1 E1EEPROM checksum does not match at start key (silent fault, not displayed).F1 E3Configuration jumper changeF1 E4Q8 shorted.F1 E9Stack overflow, highest priority fault.F1-E0Electronics subsystem failureF1-E1Electronics subsystem failureF1-E2Electronics subsystem failureF1-E3Electronics subsystem failureF1-E4Q8 shorted.F1-E5Electronics subsystem failureF1-E9Electronics subsystem failureF2Keyboard shorted / Cancel not operating.F2 E0Cancel key level too low (open).F2 E2Cancel key loop test failed.F2 E3Key held down too long or keyboard short.F2 E4Keys unsettled, probably due to noise.F2-E0Keypad subsystem failureF2-E1Keypad subsystem failureF2-E2Cancel key loop test failed.F2-E3Key held down too long or keyboard short.F2-E4Keypad subsystem failureF2-E5Keypad subsystem failureF3Oven probe shorted or open.F3 E0Oven temperature sensor (PLAT sensor) open.F3 E1Oven temperature sensor (PLAT sensor) shorted.F3 E2Oven temperature too high (runaway).F3-E0Cavity temperature sensor failureF3-E1Cavity temperature sensor failure
View all 57 error codes
F3-E2Cavity temperature sensor failureF3-E3Cavity temperature sensor failureF4Meat probe shorted.F4 E1Meat probe shorted (less than 1500 ohms).F4-E1Meat probe failureF5Door signal inconsistent.F5 E1Self-clean latch will not make after 30 seconds.F5 E3Loss of 120 VAC across L1 to ground, or Q19 circuit error.F5 E5Self-clean temperature not satisfied after 30 minutes.F5 E6Door locked with door open.F5 E7Door unlocked and will not unlatch.F5-E0Latch subsystem failureF5-E1Latch subsystem failureF5-E3Latch subsystem failureF5-E5Latch subsystem failureF5-E6Door locked with door open.F5-E7Latch subsystem failureF6Power failureF6 E0Ambient sensor opened (too hot).F6-E0Electronics over-temperatureF6-E1Electronics over-temperatureF6-E2Electronics over-temperatureF7Control or keypad switches shorted.F7 E0Input switches will not follow their strobe level (shorted to ground).F7-E0Digital switch signal (5 VDC @ 1kHz) failureF9Power failurePFPower failure

Service modes (36)

  • Bake Temperature Offset AdjustmentPush and hold the BAKE key for four (4) seconds
  • Convection Freestanding/Slide-In Board ProgrammingAfter powering up the unit, press the following keypads in sequence
  • Convection Freestanding/Slide-In Control ProgrammingAfter unit is powered up, press the following keypad sequence
  • Hidden Codes / Diagnostic AccessPress and hold each of the following pads for 5 seconds
  • Hidden Codes / Diagnostic ModePress and hold each of the following keypads for 5 seconds to access hidden functions
  • Hidden Functions - Bake Temperature CalibrationTouch and hold the Bake keypad for 5 seconds.
  • Hidden Functions - Calibration (Bake keypad)Touch and hold the Bake keypad for 5 seconds.
  • Hidden Functions - Clock Display OffTouch and hold the Clock keypad for 5 seconds.
  • Hidden Functions - Clock Display Off (Clock keypad)Touch and hold the Clock keypad for 5 seconds.
  • Hidden Functions - DehydrateTouch and hold the Conv
  • Hidden Functions - Dehydrate (Conv. Bake keypad)Touch and hold the Conv
  • Hidden Functions - End-of-Cycle Tones OffTouch and hold the Cook Time keypad for 5 seconds.
  • Hidden Functions - End-of-Cycle Tones Off (Cook Time keypad)Touch and hold the Cook Time keypad for 5 seconds.
  • Hidden Functions - Fahrenheit/Celsius ToggleTouch and hold the Broil keypad for 5 seconds.
  • Hidden Functions - Fahrenheit/Celsius Toggle (Broil keypad)Touch and hold the Broil keypad for 5 seconds.
  • Hidden Functions - Keypad Entry Tones OffTouch and hold the Stop Time keypad for 5 seconds.
  • Hidden Functions - Keypad Entry Tones Off (Stop Time keypad)Touch and hold the Stop Time keypad for 5 seconds.
  • Hidden Functions - Keypad LockoutTouch and hold the #3 keypad for 5 seconds.
  • Hidden Functions - Keypad Lockout (3 keypad)Touch and hold the #3 keypad for 5 seconds.
  • Hidden Functions - Last F/E Code and ROM RevisionTouch and hold the #0 keypad for 5 seconds.
  • Hidden Functions - Last F/E Code and ROM Revision (0 keypad)Touch and hold the #0 keypad for 5 seconds.
  • Hidden Functions - Raising Bread (Baked Goods keypad)Touch and hold the Baked Goods keypad for 5 seconds.
  • Hidden Functions - Raising Bread DoughTouch and hold the Baked Goods keypad for 5 seconds.
  • Hidden Functions - Range Configuration DisplayTouch and hold the #1 keypad for 5 seconds.
  • Hidden Functions - Range Configuration Display (1 keypad)Touch and hold the #1 keypad for 5 seconds.
  • Hidden Functions - Sabbath Mode (6 keypad)Touch and hold the #6 keypad for 5 seconds (after oven has finished preheating in Bake mode).
  • Hidden Functions - Sell ModeTouch and hold the Timer Cancel keypad for 5 seconds.
  • Hidden Functions - Sell Mode (Timer Cancel keypad)Touch and hold the Timer Cancel keypad for 5 seconds.
  • Hidden Functions - Timer Operating Tones OffTouch and hold the Timer Start keypad for 5 seconds.
  • Hidden Functions - Timer Operating Tones Off (Timer Start keypad)Touch and hold the Timer Start keypad for 5 seconds.
  • Hidden Functions - Tone Frequency ChangeTouch and hold the #7 keypad for 5 seconds.
  • Hidden Functions - Tone Frequency Change (7 keypad)Touch and hold the #7 keypad for 5 seconds.
  • Non-Convection Freestanding/Slide-In Board ProgrammingAfter powering up the unit, press the following keypads in sequence
  • Non-Convection Freestanding/Slide-In Control ProgrammingAfter unit is powered up, press the following keypad sequence
  • Sabbath Mode1
  • Temperature Calibration1

Full entry steps, exit procedures, and test sequences are available in Max.

Related KitchenAid range models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass