Model reference
KitchenAid KFGG500EBS4
Range
6 documents20 error codes16 service modes
Available documentation
Tech Sheet
- Tech Manual - Tech Sheet W1138319916 pg
- Fiche technique - Tech Sheet W106940298 pg
- Tech Sheet W113823132 pg
Quick Reference
- Manual de referencia rápida1 pg
- Freestanding Gas Range Control Guide21 pg
Installation Guide
- Freestanding Gas Range Owner's Manual56 pg
MyPros+ Max
Diagnose your KitchenAid KFGG500EBS4.
- Step-by-step diagnostics from the service manual
- Test values, resistance specs, and wiring references
- Verified part numbers when replacement is needed
Start diagnosing
$29/month · Cancel anytime · Or $9.95 3-day pass
Error codes (20)
CodeMeaning
F1-E0EEPROM communication error.F1-E5Sensor out of range.F1-E7PCB thermistor open or shorted.F1E7Board thermistor open or short circuit.F2-E0Keypad disconnected.F2-E1Stuck key.F2-E2Cancel key error.F2E0Keypad disconnected.F2E1Stuck key detected.F2E2Cancel key error.F3-E0Main oven sensor open or shorted.F3-E2Warming drawer sensor open or shorted.F3E0Main oven temperature sensor open or shorted.F3E2Warming drawer sensor open or shorted.F5-E0Door and switches do not agree (Clean modeF5E0Door and switches do not agree (Clean modeF6-E1Over temperature cook condition.F6-E3Over temperature (warming drawer).F6E1Over temperature during cook operation.F6E3Over temperature in warming drawer.Service modes (16)
- Auto Test1
- Diagnostic / Service ModePress CANCEL > CANCEL > START
- Diagnostics / Auto Test1
- Diagnostics Mode (Maxwell Control)Press CANCEL > CANCEL > START
- DISPLAYEnter Diagnostics Mode, scroll to step 5 (DISPLAY).
- ENG MODEEnter Diagnostics Mode, scroll to step 2 (ENG MODE)
- ENG MODE (Engineering Mode)From diagnostic mode, scroll to step 2 (ENG MODE)
- FAULTSEnter Diagnostics Mode, scroll to step 7 (FAULTS).
- RELAY USAGEEnter Diagnostics Mode, scroll to step 8 (RELAY USAGE).
- Temperature Adjustment (Temp Calib)1
- Temperature CalibrationPress OPTIONS until 'Temp Calib' is displayed
- TEST MODEEnter Diagnostics Mode, scroll to step 3 (TEST MODE)
- TEST ON (Relay Checks)Upon entry into Diagnostics Mode (CANCEL > CANCEL > START), TEST ON is the initial screen
- TEST ON (Relay Control)Displayed immediately upon entering diagnostic mode (CANCEL>CANCEL>START)
- USAGEEnter Diagnostics Mode (CANCEL > CANCEL > START), scroll to step 1 (USAGE).
- VERSIONEnter Diagnostics Mode, scroll to step 4 (VERSION).
Full entry steps, exit procedures, and test sequences are available in Max.
Related KitchenAid range models
78,000+ service manuals · 160,000+ error codes · 55+ brands
Get Started$29/month · Cancel anytime · Or $9.95 3-day pass