mypros+
Model reference

Magic Chef 82LA-2K

Cooktop

1 document25 error codes12 service modes

Available documentation

Other

  • W11082888 - Rev D64 pg
    Covers this model
MyPros+ Max

Diagnose your Magic Chef 82LA-2K.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax

Error codes (25)

CodeMeaning
Extra Rinse LED + Clean LEDTurbidity Sensor failure detected during Field Service Test.F0E2Oversuds condition detectedF0E4High water temperature detected during rinse cycle (105°F / 40°C or higher).F0E5Off balance load detected.F1E1Main control fault.F1E2Motor control faultF2E1Stuck keyF2E3Switch mismatchF3E1Pressure system faultF5E1Lid switch faultF5E2Lid lock faultF5E3Lid unlock faultF5E4Lid not opened between cyclesF7E1Basket speed faultF7E5Shifter faultF7E6Motor faultF7E7Motor unable to reach target RPMF8E1No fill / long fillF8E3Overflow conditionF8E5Hot and cold inlet hoses are reversed.F9E1Long drainHeated Dry LED + Clean LEDMemory / Software failure detected during Field Service Test.Heavy Wash LED + Clean LEDThermistor failure detected during Field Service Test.Light Wash LED + Clean LEDMotor low current condition detected during Field Service Test or wash cycle.Normal Wash LED + Clean LEDMotor high current condition detected during Field Service Test or wash cycle.

Service modes (12)

  • Automatic Test Mode["Enter Service Diagnostic Test Mode.","Turn cycle selector knob until only the 'Drain/Spin' LED is…
  • Calibration Mode["Enter Service Diagnostic Test Mode.","Turn cycle selector knob until only the 'Rinse' LED is…
  • Fault Code Display Mode["Enter Service Diagnostic Test Mode.","Turn cycle selector knob until only the 'Done' LED is…
  • Field Service TestPress the Heated Dry key 5 times followed by the Start key within 6 seconds
  • Manual Function TestPress the Sanitize key 5 times followed by the Start key within 6 seconds
  • Manual Test Mode["Enter Service Diagnostic Test Mode.","Turn cycle selector knob until 'Drain/Spin' and 'Done' LEDs…
  • Sales Floor Demo ModePress Extra Rinse keypad 5 times within 6 seconds.
  • Service Diagnostic Test Mode Entry["Ensure washer is in standby mode (plugged in with all indicators off).","Wait 10 seconds after…
  • Service Diagnostic Test Modes (entry)["Ensure washer is in standby mode (plugged in with all indicators off). Wait 10 seconds after…
  • Software Version Display Mode["Enter Service Diagnostic Test Mode.","Turn cycle selector knob until 'Rinse,' 'Drain/Spin,' and…
  • Tachometer Verification Mode["Enter Service Diagnostic Test Mode.","Turn cycle selector knob until 'Wash' and 'Done' LEDs are…
  • UI Test Mode["Enter Service Diagnostic Test Mode.","Turn cycle selector knob until 'Rinse' and 'Drain/Spin'…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Magic Chef cooktop models

75,000+ service documents · 20,000+ error codes · 100+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax